JVC KD-S50 manual Tuning into a preset station, Other convenient tuner functions, FM1 FM2 FM3

ENGLISH

Manual preset

You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.

Ex: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band.

Notes:

•A previously preset station is erased when a new station is stored in the same preset number.

•Preset stations are erased whent the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

1 Select the band (FM1 – 3) you want to store FM stations into (in this example, FM1).

•Each time you press the button, the FM band changes as follows:

Tuning into a preset station

You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see ”Storing stations in memory” on page 7 and 8.

F M

A M

FM1FM2 FM3

AM

1 Select the band (FM1 – 3, AM).

F M

FM1FM2

FM3

A M

2 Tune into a station of 88.3 MHz.

Press ¢ to tune stations of higher frequencies.

Press 4 to tune stations of lower frequencies.

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

AM

2 Select the number (1 – 6) for the preset station you want.

7 8 9 10 11 12

Other convenient tuner functions

RPT

SCAN

”P1” flashes for a few seconds.

4 Repeat the above procedure to store other stations into other preset numbers.

Scanning broadcast station

When you press RPT/SCAN while listening to the radio, station scanning starts. Each time a broadcast is tuned in, scanning stops for about 5 seconds (tuned frequency number flashes on the display), and you can check what program is now being broadcasted.

If you want to listen to that program, press the same button again to stop scanning.

8