Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.

Voltage change

This washer is assembled for 220V, but can be changed from 220V to 127V. Check your electrical source and follow the diagram below to convert voltage.

Green

Blue

White

(1). Please first pull off the power plug and hang up the power cord.

(2). Loosen the fastening screw and take off the back cover.

(3). Unknit the safeguard bag to expose the connectors.

(4). Detach the white connector from the green one(220V), then inlay it into the blue one(127V).

(5). Pack all the connectors with the safeguard bag as usual and fix it. Then install the back cover.

Above all the steps must be done by the special serviceman.

Install the lint filter

After opening the package, please take out the lint filter from the document bag, install it to the overflow filter of the wash tub. See to the figure.

Overflow filter

Lint filter