Installation and adjustment Before Usingi
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Install the inner cover components
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of I side into the correspon
Outer tub cover shaft groove
Inner cover shaft
Outer tub cover
Inner cover
Install the bottom plate
After opening the package, please lean the washing machine gently down on soft items (like towel cloth, blanket, etc.). Install the bottom plate to the bottom of the machine with eight screws by a c r o s s s c r e w d r i v e r, t h e n l i f t t h e machine up gently. See to the figure:
Back
Front
Bottom plate | Screw | Soft items |
Adjust the Installation position
The largest allowed slope of the shank base of the machine is 2 
. The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal
Hang the plumb to confirm it's horizontal
Adjust the adjustable foot
(1) | To twist the adjustable foot at the right front of |
|
|
| the cabinet (front the sight of front), please first |
| adjustable nut |
| lift up the side of the foot slightly, loosen the | Loosen | Fasten |
| adjustable nut, and twist the foot. |
| adjustable foot |
|
|
| |
(2) | Fasten the nut after adjustment. | High | Low |
|
| ||
|
|
|
|