Install the water inlet hose Before using
Install the water inlet hose
1.Insert a new flat washer into each end of the inlet hoses. Firmly put the washers in the coupling.
Note:
Use the new hose sets supplied with the washer. Any other old hose sets should not be used.
You may have to use pliers to tighten the coupling. Do not over tighten because you may cause damage to the valve.
2.Connect the water inlet hoses to the water faucet.
3.Connect the other ends to their respective cold and hot water inlet valve
located at the rear of the washer
Nut of the water inlet hose
Water absorption cushion
Jointer of the water inlet valve
4.Fasten the nut. Swing it gently to confirm if it's suitable.
Check the connection between the water inlet hose and the water tap
1.Swaying the hose gently to confirm if it is fastened stable.
2.After installation, open the tap to check if it leaks. 3.Do not bend the hose with overstrain.
4.Before each usage please check if the connection between the water inlet hose and the water tap, and the connection between the water inlet hose and washer are firm, so as to prevent dropping from improve Installation position.
Take down the water inlet hose
1.Close the water tap.
2.Pull off the water inlet hose from the water tap and washer