Trouble-shooting Answers to question
If the laundries fall to the outer side of the spin tub
If the laundries fall to the outer side of the spin tub, please take them out immediately.
1.Dismantle
As indicated in the figure, push the point marked with " 
" to pull the spin tub frame to oblique upwards to dismantle it.
2.Install
After install the back edge of the spin tub frame to proper position, push the four points marked with "
" by force to reset it.
Please check carefully. The laundries may fall to the lower part of the outer side of the spin tub (as indicated in the figure).
If the laundries fall to the outer side of the spin tub, during spinning the draining will get blocked and the rotation speed of the spin tub is reduced. 
Spin tub frame
Spin tub
Laundries
When the remained water is frozen
Prevent the freezing (be sure to discharge the water completely after using) 
After complete draining, set the "WASH SELECTOR" at 
STRONG 
or 
SOFT 
. If it is set at "DRAIN", it will be rather difficult for the frozen water
to melt.
Below 50 
2~3L
When the water is frozen
Pour hot water below 50 
into the wash tub to soak it completely. Then turn the pulsator with hands gently. Please confirm the drainage can work normally before next using.