Haier WMS650 user manual Introduction of the major function

Introduction of the major function Before Using

The machine has good comprehensive performance, and nice appearance.

It adopts streamline appearance and full plastic shell, which will never get rust.

For the design on safety and reliability, it adopts the wash shelf, spin shelf and water inlet groove design, and reduces the unfavorable influence on the electrical component by the vapor. Therefore it guarantees more safe and reliable washing.

It adopts complete enclosed base frame and low-noise motor, and thus reduces the working noise significantly. We can guarantee that the purchase of this machine will bring you a clean world without disturbing your quiet life.

Filling water from wash water-filling entrance

The appliance is to be connected to the water mains using new hose-sets and that old hose- sets should not be reused.

Insert the water inlet hose into the water-filling

entrance, then push the water-filling jointer into

the entrance on the control panel. (To dismantle

the water inlet pipe, just push the control handle

as indicated in the figure and pull it out)

Water inlet hose

Push	Water-filling jointer
	Wash water-filling entrance
Control handle

Foam-removing spinning during high-efficiency rinsing

Use the foam-removing spinning to		Water inlet hose
remove the extra detergent liquid. It
can both shorten the washing time
and save the water consumption.
	Foam-removing
	spinning

Spin
Fill	water for	Spin for about
about 1 minutes		1~2 minutes
Remove most of	Remove the detergent
the foam extra
detergent liquid.	liquid remained

Spin water-filling entrance

The effect is best when the laundries quantity is below 80% of the rated value.

When foam-removing spinning during high-efficiency rinsing, please fill water from the spin water-filling entrance.