Haier XPB70-113S user manual Cleaning the overflow filter

Page 15

Cleaning the overflow filter

2.Take off the corrugation pipe. Dismantle the upper part of the

corrugation pipe inside the overflow filter ( as indicated in Figure 1).

3. Cleaning the overflow filter Clean the lint around the filter and flush with tap water.

4. Install the overflow filter.

 

(1).Install the corrugation pipe.

 

(2).Insert the mounting plate at

Hook

the bottom of the filter into

 

the valve cover.

 

(3).Hang up the hook at the left

 

upper side.

 

(4).Push the upper part in as

 

indicated in Figure 2.

 

Water level adjusting lever

Corrugation

Pipe

Figure 1

Figure 2

Disposal of the complete unit

Wipe the complete unit with soft cloth twisted dry.

Wipe with neutral detergent if too dirty

Do not wash it directly by water

Alcohol Petrol Thinner

After washing, dismount the water inlet hose.

Do not store water in the tub for long period. Discharge the water immediately after each using.

Pull off the power plug and hang up the power cord.

Hang up the drain hose.

Wipe off the water drops on the surface and inside the tub with clean soft cloth. Open the cover of the wash tub and the inner/outer cover of the spin tub for some time (about one hour), then close them.

13

Image 15
Contents Twin-tub Washing Machine Contents Names of the parts Meaning and description of the symbolsSafety precautions Petrol Install the lint filter Installation and adjustmentHow to change the direction of the drain hoses Pay attention to followings before washing the laundries Preparation before washingUsage of the detergent Musts in washingWashing sequence Midway spinning Rinse with water-filing RinsingSpinning Disposal after washing Cleaning the lint filterCleaning the overflow filter When the remained water is frozen Trouble-shooting Answer to questionTrouble-shooting Answer to question Packing list Specification