JVC KD-S12 manual Maintenance

Page 14

Maintenance

ENGLISH

How to clean the connectors

Frequent detachment will deteriorate the connectors.

To minimize this possibility, periodically wipe the connectors with a cotton swab or cloth moistened with alcohol, being careful not to damage the connectors.

Connector

Moisture condensation

Moisture may condense on the lens inside the CD player in the following cases:

After starting the heater in the car.

If it becomes very humid inside the car. Should this occur, the CD player may malfunction. In this case, eject the disc and leave the unit turned on for a few hours until the moisture evaporates.

To keep discs clean

A dirty disc may not play correctly. If a disc does become dirty, wipe it with a soft cloth in a straight line from center to edge.

Do not use any solvent (for

example, conventional record cleaner, spray, thinner, benzine, etc.) to clean discs.

To play new discs

New discs may have some rough spots around the inner and outer edges. If such a disc is used, this unit may reject the disc.

To remove these rough spots, rub the edges with a pencil or ball-point pen, etc.

How to handle discs

When removing a disc from Center holder

its case, press down the center holder of the case and lift the disc out, holding it by the edges.

Always hold the disc by the edges. Do not touch its recording surface.

When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up).

Make sure to store discs into the cases after use.

Do not use the following discs:

Sticker

Sticker

 

Stick-on

Warped

residue

Disc

label

disc

 

 

 

14

Image 14
Contents CD Receiver Receptor CON CD KD-S12Information For U.S.A How to forcibly eject a discHow to reset your unit Contents How to detach/attach the control panel How to read this manualHow to use the Mode button Display window Control panel KD-S12Parts identification To turn off the power Getting startedTo activate the display demonstration Canceling the display DemonstrationsSetting the clock Radio operations When an FM stereo broadcast is hard to receiveFM station automatic presetting SSM Strong-station Sequential MemoryListening to a preset station Manual presettingTo stop play and eject the disc Disc operationsProhibiting disc ejection To check the current clock time while listening to a discMode Mode Plays at randomSelecting the playback modes For Preset values Sound adjustmentsAdjusting the sound Indication RangeGeneral settings PSM Basic procedureMaintenance General settings-PSM More about this unitTroubleshooting Symptoms Remedies/CausesSpecifications Audio Amplifier SectionRefer to page of How to reset your unit CallParts list for installation and connection Removing the unitTypical Connections Connecting the external amplifierPrecautions on power supply and speaker connections