LG Electronics TD-V10247G, TD-V14247G Read ALL Instructions Before USE, Basic Safety Precautions

Page 5

Part 2 IMPORTANT WARRANTY AND SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USE

WARNING For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life.

Your Safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word DANGER or WARNING. These words mean:

DANGER You can be killed or seriously injured if you don’t Immediately follow instructions. WARNING You can be killed or seriously injured if you don’t follow instructions.

All safety messages will tell you what the potential hazard is, tell you how the reduce the chance of injury, and tell you what can happen if the instructions are not followed.

BASIC SAFETY PRECAUTIONS

WARNING To reduce the risk of fire, electric shock or injury to persons when using your appliance, follow basic precautions, including the following :

Read all instructions before using the dryer.

Before use, the dryer must be properly installed as described in this manual.

Do not place items exposed to cooking oils in your dryer. Items contaminated with cooking oils may contribute to a chemical reaction that could cause a load to catch fire.

Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleaning solvents, other flammable or explosive substances as they give off vapors that could ignite or explode.

Do not reach into the dryer if the drum is moving.

Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published user-repair instructions that you understand and have the skills to carry out.

Do not tamper with controls.

Before the dryer is removed from service or discarded, remove the door to the drying compartment.

Do not allow children to play on or in the dryer. Close supervision of children is necessary when the dryer is used near children.

Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.

Do not use heat to dry articles containing foam rubber or similarly textured rubber-like materials.

Keep area around the exhaust opening and adjacent surrounding areas free from the accumulation of lint, dust, and dirt.

The interior of the dryer and exhaust vent should be cleaned periodically by qualified service personnel.

Do not install or store the dryer where it will be exposed to the weather.

Do not reach into the dryer while parts are moving.

Always check the inside of the dryer for foreign objects

Clean lint screen before or after each load.

SAVE THESE INSTRUCTIONS

5

Image 5
Contents TD-V10247G TD-V14247E TD-V14247G Table of Contents Accessories Part 1 SpecificationsSeeking Warranty Service Part 2 Important Warranty and Safety InstructionsRead ALL Instructions Before USE Basic Safety PrecautionsGrounding Instructions What to do if YOU Smell GAS Safety Instruction for Installation Exhaust/Ducting Safety Instruction for InstallationSafety Instruction for Connecting Electricity Positioning the Dryer Part 3 Initial Steps for Installing Your DryerReversing the Door Procedure forDoor and latch should be aligned at the center when closed Venting System Connecting the ExhaustElectrical Plug Connections If changing the orifice, also adjust the gas valveConnection of Gas Supply Operation Preparation of the DryerConfirming Heat Source Dryer AirflowStacking Kit Installation Instructions Part 4 Accessories InstallationPedestal accessory includes Pedestal Installation InstructionsInstructions for Grounding of your Electric Dryer Part 5 Electrical Requirements for Electric DryersWire connection Direct wire Wire directOption 1 4-wire connection with a power supply cord Connection Option 2 3-Wire connection with a power supply cordOption 3 Optional 3-wire Electrical Requirements for Your Dryer Part 6 Electrical Requirements for GAS DryersVolt, 60 Hertz, with 3-Prong Grounding Plug Part 7 GAS Requirements and Instructions Exhaust Requirements and Instructions Part 8 Exhaust Requirements and MaintenanceCleaning the Lint Screen Exhaust and Dryer MaintenancePart 9 Operating Your Dryer Power ButtonFire Hazard Explosion HazardSensor Dry Temp Time Cycles Load Type Minutes Cycle SelectionManual Dry Temp Cycles Load Type MinutesTime Change Button Custom ProgramLED Display Estimated Time RemainingBeeper Option ButtonsTime Dry Temp. ControlType of Load Default Time Minutes When Using Air DryDry Level Start / Pause ButtonClean the door and its opening Drying will continue from where the cycleQuestion What to Do Part 10 Troubleshooting GuideTE1 TE2Problem There Is Lint On My Clothes Troubleshooting Guide TD-V10247G TD-V14247E TD-V14247G Contenido Accesorios Parte 1 EspecificacionesBúsqueda DE Asistencia Sobre LA Garantía Parte 2 Garantía E Instrucciones DE Seguridad ImportantesGuarde Estas Instrucciones Precauciones Básicas DE SeguridadInstrucciones Para LA Toma a Tierra QUÉ a Hacer SI Huele GAS Instrucción DE Seguridad Para LA Instalación Escape/Conducto Instrucción DE Seguridad Para LA Conexión DE Electricidad Debería asegurar las patas niveladoras SecadoraPaso 1 Colocación de la Procedimiento para Invertir la PuertaPaso 3 Conexión del Sistema de Escape y Ventilación AdvertenciaConecciòn Elèctrica Paso 4 Conexión del Suministro de GasPaso 6 Preparación de la Paso 8 Flujo de AireConfirmación de la Fuente de Calor en Secadoras a Gas Confirmación de la Fuente de Calor en Secadoras EléctricasInstrucciones de Instalaciòn para montar el Kit Parte 4 Instalaciòn DE AccesoriosEl accesorio de pedestal incluye Instalacion de la secadora Cinta de tipo doble-caraAdvertencia Tomacorriente de 3-alambres Tipo Nema 10-30R Cables directosConexiòn de 4-cables Cableado directo Opción 1 Conexión de 4-alambres con Conexiòn de 3-cables Cable DirectoSección AlambresOpción 3 Conexión Opcional de Requerimientos Eléctricos para su Secadora Parte 6 Requerimientos Eléctricos Para Secadoras a GASInstrucciones y Advertencias Parte 7 Requerimientos E Instrucciones Sobre EL GASRequerimientos e Instrucciones del Escape Parte 8 Requerimientos Y Mantenimiento Sobre EL EscapeLimpieza de la Malla de Pelusa Botón de encendido Parte 9 Usando SU SecadoraPeligro de Explosión Peligro de IncendioMinutos Selección del cicloTiempo Botón de cambio de tiempo FavoritoLa Pantalla de LED Tiempo rest. estimadoBotones Opción AlarmaTiempo de Secado Control tempArranque de seu secadora Nivel de Secado11 Botón de arranque / pausa Limpiar el filtro atrapapelusa MantenimientoPregunta Qué Hacer TE1 Parte 10 Guía Para LA Solución DE ProblemasPregunta Qué Hacer Parte 10 Guía Para LA Solución DE Problemas