JVC KD-S10, KD-S5050 manual Maintenance, Handling discs, How to handle discs, Moisture condensation

Page 18

MAINTENANCE

ENGLISH

Handling discs

This unit has been designed to reproduce CDs and CD-Rs (Recordable).

•This unit is not compatible with MP3 discs.

When playing a CD-R

Before playing back CD-Rs, read their instructions or cautions carefully.

•

Use only “finalized” CD-Rs.

•

Some CD-Rs may not play back on this unit

 

because of their disc characteristics, and for

How to handle discs

Center holder

the following reasons:

– Discs are dirty or scratched.

When removing a disc from its case, press down the center holder of the case and lift the disc out, holding it by the edges.

•Always hold the disc by the edges. Do not touch its recording surface.

When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up).

• Make sure to store discs into the cases after use.

To keep discs clean

A dirty disc may not play correctly. If a disc does become dirty, wipe it with a soft cloth in a straight line from center to edge.

To play new discs

New discs may have some rough spots around the inner and outer edges. If such a disc is used, this unit may reject the disc. To remove these rough spots, rub the edges with

a pencil or ball-point pen, etc.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

•After starting the heater in the car.

•If it becomes very humid inside the car. Should this occur, the unit may malfunction. In this case, eject the disc and leave the unit turned on for a few hours until the moisture evaporates.

– Moisture condensation on the lens inside

the unit.

– The pickup lens inside the unit is dirty.

• CD-Rs are susceptible to high temperatures or

high humidity, so do not leave them inside

your car.

• Do not use following CD-Rs:

– Discs with stickers, labels, or protective seal

stuck to the surface.

– Discs on which labels can be directly printed

by an ink jet printer.

Using these discs under high temperatures or high humidity may cause malfunctions or damage to discs For example,

–Stickers or labels may shrink and warp a disc.

–Stickers or lables may peel off so discs cannot be ejected.

–Print on discs may get sticky.

Read instructions or cautions about labels and printable discs carefully.

•CD-RWs (Rewritable) cannot be played back on this unit.

CAUTIONS:

•Do not insert 8 cm (3 3/16") discs (single CDs) into the loading slot. (Such discs cannot be ejected.)

•Do not insert any disc of unusual shape — like a heart or flower; otherwise, it will cause a malfunction.

•Do not expose discs to direct sunlight or any heat source or place them in a place subject to high temperature and humidity. Do not leave them in a car.

•Do not use any solvent (for example, conventional record cleaner, spray, thinner, benzine, etc.) to clean discs.

Sticker

Stick

 

Stick-on

residue

Disc

Warped

label

disc

 

 

 

 

 

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents KD-S5050/KD-S10 For customer UseHow to reset your unit Information For U.S.ASEL Select Contents Display window Location of the ButtonsControl panel Display windowTo turn off the power Turning on the powerTo drop the volume in a moment Basic OperationsSearching a station automatically Auto search Radio OperationsListening to the radio Searching a station manually Manual searchWhen an FM stereo broadcast is hard to receive FM station automatic preset SSMStoring stations in memory Tune in to a station of 92.5 MHz Tuning in to a preset stationManual preset Select the band FM1 3, AMTo stop play and eject the CD CD OperationsPlaying a CD Insert a disc into the loading slotPortion on a CD To fast-forward or reverse the trackTracks To cancel the prohibition and unlock the CD Prohibiting CD ejectionWhile pressing CD, press and hold 0 for more than 2 seconds Adjust the level Sound AdjustmentsAdjusting the sound Select the item you want to adjustFor Preset values Select the sound mode you wantWhen SCM Link is set to Link ON, select the source Recalling the sound modesCall up the sound mode you want to adjust Storing your own sound adjustmentsTo reset to the factory settings Repeat the same procedure to store other sound modesSetting the clock Cancelling Advanced SCMOther Main Functions VOL 2 or OFF Select the desired mode VOLSelecting the level display Press and hold SEL for more than 2 secondsYou can detach the control panel when leaving the car Detaching the control panelAttaching the control panel Handling discs MaintenanceHow to handle discs Moisture condensationWhen it is ejected TroubleshootingSymptoms Causes Remedies Be careful not to drop the CDAM Tuner SpecificationsFM Tuner Sensitivity 20 µV Selectivity 35 dBCall EN, SP, FRUnit becomes hot Fuse blowsSound is distorted El fusible se quemaBe sure to keep the handles after installing it Asegúrese de conservar las manijas después de instalarloBe sure to ground this unit to the car’s chassis NotaRemarque Only for KD-S5050 KD-S5050

KD-S5050, KD-S10 specifications

The JVC KD-S5050 and KD-S10 are two excellent car CD receivers that showcase JVC's commitment to delivering quality sound and user-friendly features for music enthusiasts on the go. Both models are designed with modern technology and features that enhance the in-car audio experience.

The JVC KD-S5050 stands out with its impressive sound quality, featuring a built-in amplifier that drives a robust output, delivering clarity and depth to your music. It supports various audio formats, including MP3, WMA, and AAC, allowing for versatile playback options. The front USB port and auxiliary input provide easy connectivity for external devices, making it simple to play music from USB drives or smartphones.

One of the standout features of the KD-S5050 is its customizable EQ settings, which allows users to tailor the sound according to their preferences. The receiver comes equipped with a 13-band graphic equalizer that can be fine-tuned for optimal performance, along with various DSP sound effects to enhance the listening experience. Additionally, the unit supports Bluetooth connectivity, enabling hands-free calling and wireless audio streaming, enhancing convenience and safety while driving.

On the other hand, the JVC KD-S10 is a more compact option without sacrificing sound quality. It features a sleek design with a simple interface that makes navigation easy. The KD-S10 includes a built-in CD player that supports various disc formats and offers a direct USB input for easy access to digital music libraries. The receiver is compatible with JVC's proprietary Sound Response technology, which enriches audio playback by optimizing the sound for different types of music.

Both models incorporate a range of safety and convenience features, such as a detachable faceplate, which adds a layer of security against theft. The built-in tuner provides access to AM and FM stations, with the capability of storing preset stations for quick access to your favorite channels.

In conclusion, the JVC KD-S5050 and KD-S10 are remarkable car audio solutions that combine quality sound, modern technology, and user-centric features. With customizable sound options, Bluetooth connectivity, and compatibility with multiple audio formats, both models cater to the diverse needs of today’s drivers, making them a worthy choice for enhancing your in-car listening experience.
Top Page Image Contents