Wire cover holder.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool completely.
To remove the cover:
Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a
To replace the cover:
Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place.
Connect electrical power to the range.
Safety Instructions Operating Instructions Care
After broiling, remove the broiler pan from the oven.
Broiler Pan & Grid
Do not clean the broiler pan or grid in a self- cleaning oven.
After broiling, remove the broiler pan from the oven. Remove the grid from the pan. Carefully pour out the grease from the pan into a proper container.
Wash and rinse the broiler pan and grid in hot water with a
If food has burned on, sprinkle the grid with detergent while hot and cover with wet paper towels or a dishcloth. Soaking the pan will remove
Both the broiler pan and grid may be cleaned with a commercial oven cleaner.
Both the broiler pan and grid can also be cleaned in a dishwasher.
Do not store a soiled broiler pan and grid anywhere in the range.
and Cleaning Troubleshooting
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Rail | Stop guide | ||
|
|
|
|
Storage Drawer Removal
To remove the drawer:
Pull the drawer out until it stops.
Lift the front of the drawer until the stops clear the guides.
Remove the drawer.
To replace the drawer:
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and push back until the stops clear the guides.
Lower the front of the drawer and push back until it closes.
Tips Customer Service
19