Installation Instructions
[] RECONNECTING GAS
Listed connector ANSI Z21.24 / CSA 6.10
APPLYPiPECOMPOUND
TOALL MALETHREADS.
| 118" NPT PIPE |
NEWMETAL | PLUG FOR GAS |
FLEXIBLEGAS | INLET PRESSURE |
LINECONNECTOR |
|
ADAPTER |
|
| |
3/8" | NPT |
ELBOW |
|
| PIPE SIZE |
ITEMSNOT SUPPLIED | AT LEAST 1/2" |
Note: The connector and fittings are designed for use onty on the original insta[tation and are not to be reused for another appliance or at another location. Keep flare end of adaptor free of ]rease, oi[ and thread sealant.
Caution: Use adapters as shown. Connector nuts must not be connected directly to pipe threads.
TIGHTEN ALL CONNECTIONS
USINGTWO ADJUSTABLE WRENCHES.
DO NOT OVERTORQUE GAS CONNECTIONS!
LEAK TEST
[,_ WARNING - NEVER USE AN OPEN FLAME TO TEST FOR GAS LEAKS.
APPLYPIPECOMPOUND
TO THEADAPTERAND
DRYERGAS INLET.
OPEN
GASVALVE.
TIGHTEN THE FLEXIBLE
GAS LINE USING TWO
ADJUSTABLE WRENCHES.
Check alt connections for leaks with soapg solution or equivalent. Apply soap solution. Leak test solution must not contain ammo- nia which could cause damage to the brass fittings. If leaks are found, close valve, retighten the joint, and repeat the soap test.
3