Installation Instructions
I_ DRYER EXHAUST TO LEFT OR BOTTOM CABINET
WARNING- BEFORE PERFORMING THIS EXHAUST INSTALLATION, BE SURE TO DISCONNECT THE DRYER FROM ITS ELECTRICAL SUPPLY. PROTECT YOUR HANDS AND ARMS FROM SHARP EDGES WHEN WORKING INSIDE THE CABINET. BE SURE TO WEAR GLOVES
REMOVE
SCREW
ANDSAVE.
O_ REMOVE
DESIRED KNOCKOUT (ONEONLY).
Detach and remove the bottom or left side knockout as
desired. Remove the screw inside the dwer exhaust duct and save. Pull the duct out of the duet.
FIXINGHOLE
BA
9"
Cut the duct as shown and kee I) portion A.
ADDING NEW DUCT
FIXING
HOLE
PORTION"A"
LEFTSIDE
EXHAUST
Reconnect dm cut portion (A) of the duct to the blower housing. Make sure that the shortened duct is aligned with the tab in the base. Use the screw saved previously to secure the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR EXHAUST TO LEFT SIDE OF CABINET
•Preassemble 4" elbow with 4" duct. Wrap duct tape around joint.
•Insert duct assembly, elbow first, through the side opening and connect the elbow to the dwer internal duct.
CAUTION: Be sure not to pull or damage the electrical wires inside the dryer when inserting the duct,
J_
TAB LOCATION
DUCT
//TAPE
BENDTAB
UP450
Through the real" opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45 ° using a fiat blade screwdriver.
•Apply duct tape as shown on the joint between the diTer internal duct and the elbow.
| DUCT |
| TAPE |
| CAUTION: |
| Internal duct joints must be |
| they may separate and cause |
| __ secured with tape, otherwise |
7 | a safety hazard. |