Gas Connection for Gas Dryers, Replacement Parts

Gas Connection for Gas Dryers

			Remove the shipping cap from gas pipe at the			Open the shutoff valve in the gas supply line.
		1	Remove the shipping cap from gas pipe at the		3	Open the shutoff valve in the gas supply line.
			rear of the dryer.			Test all connections by brushing on a soapy
		NOTE: DO NOT connect the dryer to LP gas service			4	Test all connections by brushing on a soapy
					4	water solution.
						water solution.
		without converting the gas valve. An LP conversion				CAUTION: NEVER TEST FOR GAS LEAKS WITH
		kit (Pub. No. 14-A038) MUST be installed by a				CAUTION: NEVER TEST FOR GAS LEAKS WITH
		kit (Pub. No. 14-A038) MUST be installed by a				AN OPEN FLAME.
		qualified gas technician.				AN OPEN FLAME.
		qualified gas technician.		NOTE: On gas dryers, before the burner will light,
				NOTE: On gas dryers, before the burner will light,
		2	Connect a 1/2″ (1.27 cm) I.D. semi-rigid	it is necessary for the gas line to be bled of air. If
			or approved pipe from gas supply line to	the burner does not light within 45 seconds the first
			or approved pipe from gas supply line to
			the 3/8″ (0.96 cm) pipe located on the back
			the 3/8″ (0.96 cm) pipe located on the back	time the dryer is turned on, the safety switch will
			of the dryer. Use a 1/2″ to 3/8″ (1.27 cm to	time the dryer is turned on, the safety switch will
			of the dryer. Use a 1/2″ to 3/8″ (1.27 cm to	shut the burner off. If this happens, turn the dryer
			0.96 cm) reducer for a connection. Apply an	shut the burner off. If this happens, turn the dryer
			0.96 cm) reducer for a connection. Apply an	off and wait 5 minutes before making another
			approved thread sealer that is resistant to the	off and wait 5 minutes before making another
			approved thread sealer that is resistant to the	attempt to light.
			corrosive action of liquefied gases on all pipe	attempt to light.
			corrosive action of liquefied gases on all pipe
			connections.
Before Operating the Dryer
			Connect the exhaust duct to outside exhaust			CAUTION: Before operating the dryer, make
	1		Connect the exhaust duct to outside exhaust			CAUTION: Before operating the dryer, make
	1		system. Use duct tape to seal all joints.			sure the dryer area is clear and free from
			system. Use duct tape to seal all joints.			sure the dryer area is clear and free from
			With the dryer in its final position, adjust one or			combustible materials, gasoline, and other
			With the dryer in its final position, adjust one or			flammable vapors. Also see that nothing
			more of the legs until the dryer is resting solidly
			more of the legs until the dryer is resting solidly
			on all four legs. Place a level on top of the dryer.			(such as boxes, clothing, etc.) obstructs the
			on all four legs. Place a level on top of the dryer.			flow of combustion and ventilation air.
			THE DRYER MUST BE LEVEL AND RESTING			flow of combustion and ventilation air.
			THE DRYER MUST BE LEVEL AND RESTING
			SOLIDLY ON ALL FOUR LEGS. Turn the lock nuts			Run the dryer through a cycle check for proper
			SOLIDLY ON ALL FOUR LEGS. Turn the lock nuts	5		Run the dryer through a cycle check for proper
			on each of the four legs up toward the base of	5		operation.
			on each of the four legs up toward the base of			operation.
			the dryer and snug with a 1/2″ open-end			Place these instructions in a location near the
			wrench.	6		Place these instructions in a location near the
				6		dryer for future reference.
						dryer for future reference.
			Plug the power cord into a grounded outlet.
	3		Plug the power cord into a grounded outlet.
	3		NOTE: Check to ensure the power is off at circuit
			NOTE: Check to ensure the power is off at circuit
			breaker/fuse box before plugging the power
			cord into the outlet.
			Turn on the power at the circuit breaker/fuse
	4		Turn on the power at the circuit breaker/fuse
			box.

Replacement Parts

Safety Instructions

Care and Cleaning

Installation Instructions

If replacement parts are needed for your dryer, contact the source where you purchased your dryer.

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING: Destroy the carton and plastic bags after the parts are unpacked. Children might use them for play. Cartons covered with rugs, bedspreads or plastic sheets can become airtight chambers causing suffocation. Place all materials in a garbage container or make materials inaccessible to children.

WARNING: The instructions in the manual and all other literature included with this dryer are not meant to cover every possible condition and situation that may occur. Good safe practice and caution MUST be applied when installing, operating and maintaining any appliance.

Customer Service