Kenmore 134313400, 417.74182300, 134316200 manual Location of Your Dryer, Do not Install Your Dryer

Page 5

LOCATION OF YOUR DRYER

DO NOT INSTALL YOUR DRYER:

1.In an area exposed to dripping water or outside weather conditions.

2.In an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air.

3.On carpet. Floor MUST be solid with a maximum slope of 1 inch (2.54 cm).

INSTALLATION IN RECESS OR CLOSET

1.A dryer installed in a bedroom, bathroom, recess or closet, MUST be exhausted outdoors.

2.No other fuel burning appliance shall be installed in the same closet as the Gas dryer.

3.Your dryer needs the space around it for proper ventilation.

DO NOT INSTALL YOUR DRYER IN A CLOSET WITH A SOLID DOOR.

4.A minimum of 120 square inches (774.2 square cm) of opening, equally divided at the top and bottom of the door, is required. Air openings are required to be unobstructed when a door is installed. A louvered door with equivalent air openings for the full length of the door is acceptable.

MINIMUM INSTALLATION CLEARANCES (Inches)

FRONT SIDES REAR TOP

Alcove

0 (0 cm)

0 (0 cm)

0 (0 cm)

15 (38.1 cm)

Closet

1 (2.54 cm)

0 (0 cm)

0 (0 cm)

15 (38.1 cm)

Closet door ventilation required: 2 louvered openings each 60 square inches (387 square centimeters) — 3 inches (7.6 cm) from bottom and top of door.

THIS DRYER MUST BE EXHAUSTED OUTDOORS.

5.The following illustrations show minimum clearance dimensions for proper operation in a recess or closet installation.

0" (0 cm)

60 SQ. IN.

(387.1 SQ. CM)

60 SQ. IN.

(387.1 SQ. CM)

CLOSET DOOR

15" (38.1 cm)

1" (2.54 cm)

0" (0 cm)

4

Image 5
Contents Replacement Parts InstallationElectrical Connections For 4-WIRE System Electrical Connections For 3-WIRE SystemGrounding Requirements Electrical InstallationReversing Door Swing UnpackingLocation of Your Dryer Do not Install Your DryerMaximum Length Exhaust System Requirements PRE-INSTALLATION RequirementsElectrical Requirements Installation Instructions Page Repair Parts List CABINET/DRUM Functional Parts 10/03 Non-Illustrated Parts Front PANEL/LINT Filter 131872000 Pin,retainer ,lint blade CONTROLS/TOP Panel Mounting Hardware,meter case ,security P16M0027 Screw,hex head ,1/4-20T x 1.25 ,spacer mtg.,thread cutting Burner 131168200 Screw,pan head ,8-18B x 131243700 Wiring Diagram