Creda Tumble Dryer manual Empty Water Container Lightwater Sink

Page 12

How To Operate Your Dryer

WATER

CONTAINER

PLINTH MOULDING WHEN FITTED

EMPTY WATER

CONTAINER

LIGHTWATER

CONTAINER

SINK

13.Remove plinth moulding (where fitted) by slightly lifting and sliding to the left. Remove the

water container and empty after EVERY programme. Failure to do this will result in the water container becoming full and the load will not dry.

NOTE: The light on the control panel only comes on when the water container is full. When the light is on you should stop the dryer and empty the water container. This should be avoided by emptying the container between cycles. If the light comes on during a cycle (Eco machines) the timer will automatically advance to ‘cool run’.

14.EVERY month, remove and clean the Condenser unit by pouring cold water through all the tubes. This prevents the air passage ways from

 

being blocked by fluff.

FLUFF

FILTER

 

 

 

TAP

REAR

FRONT

CONDENSER

12

Image 12
Contents Condensing Tumble Dryer Contents EEC StandardsFeatures Getting to Know Your Dryer Important Safety Points NeverInstallation of your Dryer LocationCaring for your Wash Items not suitable for your DryerSorting your laundry Maximum Dry Load Size Typical LoadClothing articles Household items Items requiring special attention How to operate your Dryer Push Here Release to Open Door120 110 Automatic Eco/Economy DryerNever switch the Dryer off, leaving a hot load in the Drum Empty Water Container Lightwater Sink Electrical Requirements Rewirable PlugMoulded Plug When not in use After each load Every week Every month CleaningCaring for your Dryer Disposal of the applianceDoes the Condenser unit need cleaning? Something Wrong?Has the fuse blown in the plug or the main fuse box? Is the Door fully closed?Service