Electrolux EDE 77550W Machine settings, Changing the bulb for interior lighting, Water hardness

Page 12

12electrolux

Displayed programme time changes erratically or stays un- changed for a long time.

Drying cycle ends shortly after programme starts.

Drying cycle lasts an unusually long time. Note: After around 5 hours the drying cycle ends au- tomatically.

Programme time is corrected automatically depending on type and volume of laundry and level of dampness.

Not enough washing loaded or washing loaded is too dry for se- lected programme.

Filter clogged.

Load volume too big.

Laundry insufficiently spun.

Automatic process; this is not a machine fault.

Select time programme or high- er drying level (e.g. EXTRA in- stead of CUPBOARD ).

Clean filter.

Reduce load volume.

Laundry must be adequately spun.

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local Service Force cen- tre.

Warning! When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.

Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!

Warning! Before replacing the bulb, disconnect the mains plug.

1.Unscrew cover above the bulb (this can be found directly behind the loading aper- ture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw cover back down.

Check the correct positioning of o-ring gas- ket before screwing back the door light cov- er. Do not operate the dryer when missing o- ring gasket on door light cover.

Warning! For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

Machine settings

SIGNAL permanent off

1.Turn the programme selector to any pro- gramme.

2.Press simultaneously the LONG ANTI- CREASE and BUZZER buttons and hold down for approx. 5 seconds.

3.The buzzer is by default always off. You can use button to activate or deactivate sound but machine does not memorize your selection.

Water hardness

Water contains, a variable quantity of lime- stone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle. Your

dryer allows you to regulate the sensitivity of the drying sensor based on conductivity val- ues of the water.

1.Turn the programme selector to any pro- gramme.

2.Press simultaneously the BUZZER and START PAUSE buttons and hold down for approx. 5 seconds. The current set-

ting is on the display:

– low con-

ductivity <300 micro S/cm,

medium conductivity 300-600 micro S/

cm,

– high conductivity >600 mi-

cro S/cm

 

3.Press the START PAUSE button sequen- tially until you set desired level.

4.To memorize setting press simultaneous- ly the BUZZER and START PAUSE but- tons or turn knob to "O" (OFF) position

Image 12
Contents Tumble Dryer Tumble Dryer EDE 77550WElectrolux. Thinking of you Contents Important safety informationInstallation Child safetyUse Product description Control PanelStart Pause button Filter light Laundry weights Before first useSorting and preparing laundry Sorting laundryProgramme chart When dry ProgrammesType of laun Dry Application/propertiesApplication/properties Care mark Max. load MIX ANTI-CREASE BuzzerDaily use Delay start Setting child lockBuzzer TimeCleaning and maintenance Cleaning fluff filterCleaning the door Cleaning the drumClean operating screen and housing Troubleshooting by yourselfMachine settings Signal permanent offChanging the bulb for interior lighting Water hardnessTechnical data InstallationAppliance positioning Removing transport safety packaging Fitting the vent hose Door reversal Electrical connectionEnvironment Packaging materialEnvironmental tips Service Model descrip- tionElectrolux. Thinking of you Daftar Isi Informasi penting tentang keselamatanBanyak sebelum dikeringkan pada tumble dryer ini PemasanganPenggunaan Deskripsi produk Panel Kontrol Sebelum menggunakan pertama kaliMemilah dan menyiapkan cucian Pesan yang diperlihatkan pada layar tampilanDiagram program Menyiapkan cucianBerat cucian Fungsi tambahan / opsi Aplikasi/properti BebanBeban maks. berat kering Fungsi tambahan / opsiPenggunaan Sehari-hari Menghidupkan mesinMembuka pintu dan memasukkan cucian Memilih programDelay Tunda Pelaksanaan Memilih fungsi tambahanDelicate Bahan Halus Long Anticrease Anti kusutPembersihan dan pemeliharaan Mulai menjalankan programMengubah program Siklus pengeringan selesai / mengeluarkan cucianMembersihkan pintu Membersihkan drumBersihkan layar dan rangka mesin Memecahkan masalah oleh Anda sendiriMengganti bohlam lampu untuk penerangan di bagian dalam MasalahPengaturan mesin Spesifikasi teknisSinyal mati selamanya Putar kenop pemilih program ke program apa sajaPemasangan Penempatan mesinMelepaskan kemasan pengaman pengiriman Memasang selang ventilasi Pembalikan pintu Sambungan listrikLingkungan Bahan pengemasSaran mengenai lingkungan Servis Deskripsi model Nomor produk PNC136910040-01-042009