Cleaning the door
Clean periodically the interior part of the door to remove any fluff. Accurate cleaning en- sures correct drying.
Cleaning the drum
Caution! Do not use abrasives or steel wool to clean the drum.
Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper
electrolux 11
than expected when removed from the dryer.
Use a standard domestic cleaner (e.g.
Clean operating screen and housing
Caution! Do not use furniture cleaners or aggressive cleaning agents to clean the machine.
Use a damp cloth to wipe down the op- erating screen and housing.
What to do if ...
Troubleshooting by yourself
If, during operation, the error code E... plus number or letter) appears on the LCD: Switch the machine off and on again. Reset pro-
gramme. Press the START / PAUSE button If the error is still displayed, please inform your local Service Force Centre and quote the error code.
Problem
Possible cause
Remedy
Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
When a button is pressed, Err appears on the LCD.
Drum light does not work.
Mains plug is not plugged in or fuse is not working correctly.
Loading door is open.
Have you pressed the START / PAUSE button?
Wrong programme selected.
Filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of drum or drum ribs.
Conductance of water at instal- lation site differs from standard setting of machine.
Filter not in place.
Washing protection. After the start of the programme, the op- tion can no longer be set.
Programme selector in "O" (OFF) position.
Defective light bulb.
Plug in at mains socket. Check fuse in fuse box (domestic in- stallation).
Close loading door.
Press the START / PAUSE but- ton again.
Select a different programme the next time you dry (see “Pro- gramme chart” chapter).
Clean filter.
Observe recommended loading volumes.
Uncover ventilation slots.
Clean inside surface of drum and drum ribs.
Install filter into place.
Turn the programme knob to "O" (OFF) . Set the programme again.
Turn programme selector to any programme.
Replace light bulb (see next sec- tion).