Electrolux EDE 77550W user manual Removing transport safety packaging Fitting the vent hose

14electrolux

Important! The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not resistant to high temperatures.

When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance.

Warning! Should the appliance be moved, it must be transported vertically.

Warning! The appliance must not be installed behind the lockable door, a sliding door or a door with a hinge on the opposite side to that of the appliance.

Removing transport safety packaging

Caution! Before use all parts of the transport packaging must be removed.

Fitting the vent hose

To simplify the installation, there is a choice of vent outlets: one at the back, the others in the left and right-hand side. Connect the hose to whichever is the more convenient by pulling the ring nut (A) from the vent outlet at the back, screwing it on to the hose and pushing it firmly back into place. The unused vents should now be sealed with the special snap covers provided.

A

A

1.Open loading door.

2.Pull off adhesive strips from inside ma- chine on top of drum.

3.Remove foil hose and polystyrene padding from the machine.

If the hose is long and the room temperature low, the moisture might condense to water inside the hose. This is an unavoidable nat- ural phenomenon. To prevent this water from Iying in the hose or flowing back into the tum- ble dryer, it is advisable to drill a small hole (via. 3 mm) in the lowest point of the hose and to place a small container below it. (See pic- ture, point B).