Important safety information, General safety

2Important safety information

	This section includes safety information that will help protection from risks of
personal injuries or materialistic damages.			to power supply in order to decrease
Failure to follow these instructions			the risk of electric shock.
shall cause any warranty and reliability		•	Do not make any changes on the plug
commitment to become void.			supplied with the product. If it is not
General safety			compatible with the socket, have a
•	Never place the machine on a carpet-		qualified electrician change the socket
			with a suitable one.
	covered floor, otherwise, lack of airflow
		•	Items cleaned or washed with gasoil/
	beneath the machine may cause
			fuel oil, dry-laundry solvents and other
	electrical parts to overheat. This will
			combustible or explosive materials as
	cause problems with your machine.
			well as the items that are contaminated
•	If the power cable or mains plug is
			or spotted with such materials should
	damaged, you must call Authorised
			not be dried in the product since they
	Service Agent for repair.
			emit flammable or explosive vapor.
•	The product should not be plugged
		•	Do not dry items cleaned with
	in during installation, maintenance
			industrial chemicals in the dryer.
	and repair works. Such works should
		•	Do not dry unwashed items in the
	always be made by the technical
			dryer.
	service. Manufacturer shall not be held
		•	Items soiled with cooking oils,
	responsible for damages arising from
			acetone, alcohol, fuel oil, kerosene,
	processes carried out by unauthorised
			stain remover, turpentine, paraffin and
	persons.
			paraffin removers must be washed
•	Connect the product to a grounded
			in hot water with plenty of detergent
	outlet protected by a fuse of suitable
			before being dried in the dryer.
	capacity as stated in the technical
		•	Garments or pillows bolstered with
	specifications table.
			rubber foam (latex foam), shower
•	Operate your product at temperatures
			bonnets, water resistant textiles,
	between +5°C and +35°C.
			materials with rubber reinforcement
•	Do not use electrical devices in the
			and rubber foam pads should not be
	product.
			dried in the dryer.
•	Do not connect the air exit of the
		•	Do not use fabric softeners and
	product to the chimney holes which
			anti-static products unless they are
	are used for the exhaust fumes of the
			recommended by the manufacturers of
	devices operating with gas or other
			the fabric softener or the product.
	types of fuel.
		•	This product must be earthed.
•	You must provide enough ventilation
			Grounding installation decreases
	in order to prevent gases exiting from
			the risk of electric shock by opening
	devices operating with other types of
			a path with low resistance for the
	fuels including the naked flame from
			electricity flow in case of a malfunction
	accumulating in the room due to the
			or failure. Power cable of this product
	back fire effect.
			is equipped with a conductor and
• Always clean the lint filter before or
			a grounding plug that allows for
	after each loading.
			grounding the product. This plug must
•	Never operate your dryer without the
			be installed appropriately and inserted
	lint filter installed.
			into a socket which is grounded in
•	Do not allow fibre, dust and dirt
			accordance with the local laws and
	accumulation around the exhaust exit
			regulations.
	and at adjacent areas.
		•	Do not install the product behind a
•	Power cable plug must be within easy
			door with a lock, sliding door or a door
	reach after installation.
			that has a hinge against the hinge of
•	Do not use extension cords, multi-
			the dryer.
	plugs or adaptors to connect the dryer
		• Do not install or leave this product