
3Installation
To make the product ready for use, make sure that the electricity and water drainage system are appropriate before installation. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out. C Preparation of the product’s location
as well as the electrical and waste water installations is the customer’s responsibility.
C Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorized persons.
APrior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety.
AThe appliance should be transported
only in a vertical upright position.
If during the course of transport the appliance has to be transported horizontally, it must only be laid on its right hand side. After bringing it to upright position,it must not be operated for at least 12 hours to allow the system to settle.
Failure to comply with the above instructions could result in damage occurring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.
Appropriate installation location
•Install the product on a stable and level surface.
•Dryer is heavy. Do not move it by yourself.
•Operate your product in a well ventilated,
•Do not block the air ducts in front of and under the product with materials
such as long pile rugs or wooden plinths.
• Do not install the product behind a door with a lock, sliding door or a hinged door which can strike the product.
• Once the product is installed, it should stay at the same place where its connections have been made. When installing the product, make sure that the rear wall of it does not touch anywhere (tap, socket, etc.). Also pay attention to select an installation location which you will not be required to change afterwards.
• Place the product at least 1.5 cm away from the edges of other furniture.
BDo not place the product on the power cable.
Removing the transportation safety assembly
ARemove the transportation safety assembly before using the product for the first time.
1.Open the loading door.
2.There is a nylon bag inside the drum that contains a piece of styrofoam. Hold it from its section marked with XX XX.
3.Pull the nylon towards yourself and remove the transportation safety assembly.
AMake sure that no part of the
9 EN