Beko DCU 8330 GX manual Water tank, For the condenser

Page 21

Water tank;

The moisture in the damp laundry is taken from the laundry and condens ed. Drain the water tank after each drying cycle or during drying when “Water tank” warning light turns on.

A Condensed water is not drinkable!

A Never take out the water tank when the programme is running!

If you forget to drain the water tank, your dryer will stop during the following drying cycles when the water tank is full and the “Water tank” warning light will turn on. If this is the case, press the “Start/Pause/ Cancel” button to resume the drying cycle after draining the water tank.

*To drain the water tank:

1-Pull the drawer and remove the water tank carefully.

2-Drain the water in the tank

3-If there is lint accumulation in the funnel of the water tank, clean it under running water.

4-Place the water tank into its seat.

For the condenser;

Hot and humid air in the condenser is cooled with the cold air from the room. Thus, the humid air circulating in your dryer is condensed and then pumped into the tank.

CClean the condenser after every 30 drying cycles or once a month.

To clean the condenser:

21

1.If a drying process has been carried out, open the door of the machine and wait until it cools down.

2.Unlock the 2 condenser locks after opening the kick plate.

3. Pull out the condenser.

4.Clean the condenser by applying pressurized water with a shower armature and wait until the water drains.

EN

Image 21
Contents Dryer DCU 8330 GX Read this manual prior to initial operation of the product General safety Important safety informationIntended use Children’s safety Installation Electrical connection Adjusting the feetFirst use Disposing of packaging materialTechnical specification Transportation of the machineDisposing of the old machine Things to be done for energy saving Initial preparations for dryingLaundry suitable for drying in the machine Laundry unsuitable for drying in the machineCorrect load capacity Preparing laundry for dryingLoading the laundry Control panel Selecting a Programme and OperatingYour MachineProgramme selection Preparing the machineShirt Time displayProgramme selection and consumption table Programme table Auxiliary function Changing the contrastDrying degree Anti-creasingCanceling the time delay Changing the delay timeStarting the programme Progress of programmeAdding/removing laundry in standby mode Changing the programme after the programme has startedChild-proof lock End of programme Ending the programme through cancelingFilter Cartridge / Door Inner Surface SensorFor the condenser Water tankPage Suggested solutions for problems