Haier HDY-D70-E Preparation, Drain switchover, Turning on power, Treatment of laundry to dry

Page 4

Installtion

Drain switchover

During the drying of the laundry, the condensate water is automatically collected in the box inside the machine, so that the water needs to be removed from the box after every drying cycle. If your dryer is in the vicinity of a drain, you may allow the condensed water to discharge directly into the drain through the drainpipe provided to avoid emptying the box every time.

The method to connect the drainpipe is as follows:

1.Loosen the hose clip with the drain switchover joint;

2.Pull the hose off the joint;

3.Install the accessory drainpipe on the joint;

4.Fix the hose in place with the clip;

Note: The outlet of the drainpipe must not be higher than 1.0 m above the floor

Preparation

Attention

Before use, clean any deposits from inside the drum of the dryer with a wet towel;

Clean debris on the filter screen to increase the drying efficiency.

Turning on power

Before turning on the power for the dryer, check:

■Whether the supply voltage is in accordance with the value indicated on the nameplate;

Whether the supply receptacle can withstand the maximum power load to the dryer;

Whether the supply receptacle is in accordance with the plug of the dryer. If not, replace the power supply cable or receptacle to make them accord with each other; The replacement of the power supply cable must be made by a qualified professional or our authorized service agent;

■The dryer must be grounded securely.

Treatment of laundry to dry

■Check whether the laundry to be dried is suitable to be dried in the dryer; ■The dryer can only dry the laundry that has been spun dry. Do not put too

wet laundry into the machine;

■Empty all pockets of the laundry with such items as keys and coins and remove the adornment that is not suitable to be dried;

■Pull up zippers, sew and mend up loosened fasteners and tie up dispersed ribbons to prevent the laundry from being entangled. If necessary, put small items into a net.

■To achieve a better drying result, shake the heavy laundry and make it loose before load it into the dryer.

Load to dry

Make sure that the laundry you are going to dry is suitable for drying in a dryer.You will find information on this on the laundry labels.The following symbols mean:

 

 

 

Dry at normal

Dry at

Drying in the

tumble dryer

temperature

reduced temperature

not possible

 

 

 

 

 

Warning: Do not dry wool, silk, down and other delicate fabrics to avoid damage to fabrics.

6

7

Image 4
Contents Name of Parts Important Safety Instructions Installtion Change the door-opening directionDrain switchover Turning on powerPreparation Treatment of laundry to dryControl Panel Program knobProgramming Guide Drying MethodsCleaning and Maintenance Trouble Shooting Prompt and Alarm InformationWiring Circuit Specifications