Cleaning and Maintenance

1.Cleaning the surface

Wipe the body of the dryer and the control panel with a damp cloth. Remember not use any organic solvent or corrosive agent to avoid damage to the machine.

2. Cleaning the filter screen

To ensure a good ventilation during drying, the filter screen must be cleaned after every drying program is complete.

Open the door and remove the filter screen from the machine. Open the screen and clean off the dust on the screen with a wet towel. After

Cleaning and Maintenance

-Using a coin or other tool, push the slides on the cover to the position as shown in the figure and then remove the cover;

-Turn the condenser's handle 90 degrees in the direction as shown in the figure;

-Remove the condenser from the dryer;

-Clean the condenser with a brush or flush with by a water jet; Note: Do not use a sharp tool in cleaning the heat exchanger, otherwise it may damage its sealing performance;

-Put the condenser back in place and lock up the cover; -Put the lower deco panel back in place.

cleaning, put the screen back in place.

3. Emptying the water collection box During operation , steam condenses into

water and is collected in the box.The box must be emptied after the program is complete. -Hold the handle and pull the box outwards to remove it. keep it level to prevent the water

from overflowing;

-Pour away water. Note: the

water can not be used for drink or for food
processing;
-Put the box back in place.If the box has not
been emptied, the dryer will sound an alarm
when the box is full. The indicator light comes
on while the box is emptied and the dryer will
stop. It will not restart until the box is emptied.
4.Cleaning the condenser	A
4.Cleaning the condenser
The condenser must be cleaned monthly.
Switch off the power supply before cleaning.
-Hold the protrusions on both sides of the
lower deco panel and open it.

5. Cleaning the drum

After the dryer has operated for a time, fabric caring agents or calcium contained in the water will form an almost invisible layer on the inside of the drum.

This makes the dryer not able to reliably and accurately identify the dryness of the laundry. So the inside of the drum, especially the stainless steel pieces on the blades must be cleaned regularly by a wet cloth.