Table of Contents
Section 4: Maintenance & Lubrication
Maintenance
Proper servicing and adjustment is the key to the long life of any implement. With careful and systematic inspection, you can avoid costly maintenance, time and repair.
After using your cutter for several hours, check all bolts to be sure they are tight.
Replace any worn, damaged or illegible safety labels by obtaining new labels from your Land Pride Dealer.
Service Cutting Blades
!DANGER!
Always disconnect main driveline from tractor PTO before servicing the underside of the cutter deck. Cutter can be engaged if tractor is started resulting in damage to the cutter, bodily injury and/or death.
!WARNING!
Always secure cutter deck in the up position with solid supports before servicing the underside of the cutter. Never work under equipment supported by hydraulics. Hydraulics can drop equipment if controls are actuated or if hydraulic lines burst. Either situation can drop the cutter instantly even when power to the hydraulics is shut off.
IMPORTANT: Replace cutting blades with genuine Land Pride blades only. Blades must be replaced in mating pairs. Not replacing both blades will result in an
Always inspect cutting blades before each use. Make certain they are properly installed and are in good working condition. Replace any blade that is damaged, worn, bent, or excessively nicked. Small nicks can be ground out when sharpening.
1.Place tractor gear selector in park and/or set brakes, shut engine off and remove ignition key.
2.Disconnect main driveline from tractor PTO and secure cutter deck in the up position with solid supports before servicing underside of cutter.
3.Inspect cutting blades. Make certain they are properly installed and are in good working condition. Replace any blade that is damaged, worn, bent, or excessively nicked. Small nicks can be ground out when sharpened.
4.To remove blades from the cutter, align blade bolts with blade bolt access hole located in the deck.
5.Both blades should be sharpened at the same angle as the original cutting edge and must be replaced or
balance. The following precautions should be taken when sharpening blades:
a.Do not remove more material than necessary.
b.Do not heat and pound out a cutting edge.
c.Do not grind blades to a razor edge. Leave a blunt cutting edge approximately 1/16” thick.
d.Always grind cutting edge so end of blade remains square to cutting edge and not rounded.
e.Do not sharpen back side of blade.
f.Both blades should weigh the same after sharpening with not more than 1 1/2 oz. difference.
Refer to Figure 4-1:
6.Make certain when installing cutter blades that the blades on one spindle is positioned 90 degrees to the blades on the other spindle as shown in Figure
7.Carefully check cutting edges of blades in relation to blade carrier rotation to ensure correct blade placement. Blade rotation is counterclockwise on the left side and clockwise on the right side as shown. Airfoil (lift) must be oriented towards the top of the deck.
CW
CCW
Blade Positioning and Rotational Directional
Figure
Refer to Figure 4-2:
IMPORTANT: Examine blade bolts (#1) and washers (#5) for excessive wear and replace if worn.
IMPORTANT: Locknuts can loose their ability to lock properly once removed. Therefore, always use a used blade nut or plain nut in steps 8 & 9 below and then replace used nut with new locknut in step 10.
8.Start by assembling blades without shim (#2). Insert blade bolt (#1) through blade (#3), dish pan (#4) and flat washer (#5). Temporary secure blade with a used 1
28 RCR2596, RCR2510 and RCRM2510 Rotary Cutters | 5/09/08 |
