Electrical Requirements, It is your responsibility

English

ELECTRICAL REQUIREMENTS

Warning

Electrical Shock Hazard

Plug into a grounded 4 prong outlet.

Failure to do so can result in death or electrical shock.

It is your responsibility

•To connect a qualified electrical installer.

•To be sure that the electrical connection is adequate and in conformance with CAN1-B149 (.1 or .2) installation codes and/or local codes.

•A 4 wire, single phase, 115/230-volt, 60-Hz., AC-only electrical supply is required on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit.

•This dryer is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-30R wall receptacle.

The cord is 5 ft (1.52 m) in length. Be sure wall receptacle is within reach of dryer’s final location.

4-wire receptacle 14-30R

If using a replacement power supply cord, it is recommended that you use Power Supply Cord Replacement. For further infromation, please reference the service numbers located in the “Assistance or Service” section of this manual.