EN
Troubleshooting
Before you call our Customer Care Department, go through the following troubleshooting suggestions:
Problem:
The dryer won’t start.
Possible causes / Solution:
�The plug is not plugged into the socket, or not making contact.
�There has been a power outage.
�The fuse has blown. Try to plug another appliance into the socket.
�You are using an extension cord? Try to plug the dryer’s power cord directly into the socket.
�The door is not closed securely?
�The PROGRAMS knob has not been set properly (see Start and Programs).
�The START button has not been pressed (see Start and Programs).
Drying cycle will not begin.
Its taking a long time to dry.
�You have set a delay time (see Start and Programs).
�The filter has not been cleaned (see Maintenance).
�The correct program has not been selected for the type of fabric you are drying (see Start and Programs).
�The exhaust duct is obstructed (see Installation).
�The air intake vent is obstructed (see Installation).
�The permanent ventilation flap on the storm cover is obstructed (see Installation).
�The items were too wet (see Laundry).
�The dryer was overloaded (see Laundry).
Program finishes and clothes | ! For safety the dryer has a maximum program time of 3 hours. If an |
are damper than expected. | automatic program has not sensed the required final moisture in this time |
| the dryer will complete the program and stop. Check the above points and |
| run the program again, if the results are still damp, contact our Customer |
| Care Department. |
The display shows a fault | � Note down the code and contact the our Customer Care Department. |
code F followed by one or two |
|
numbers. |
|
If you still have a problem, call our Customer Care Department at:
10