Electrical Connection

5.Unscrew hinge A from the load door and turn it through 180°, then put on the opposite side and screw down.

6.Turn cover plates B through 180° and put them on the opposite side.

7.Unscrew cover plates D from the front of the appliance, turn through 180° and screw down on the oppo- site side.

E F F

8.Unscrew door lock E, push down lightly and remove from the front of the appliance.

9.Push snap-in button F in and down, push cover down lightly and re- move from front of the appliance.

10.Change door lock E above to the opposite side, screw down the door interlock.

11.On the other side, put cover F and let snap-in button to lock into posi- tion.

12.Put load door and hinges into re- cesses on the front of the appliance and screw down.

Note regarding contact pro- tection: The appliance is only secure for operations again once all plastic parts have been put.

•Connect the appliance to a groun- ded socket. Refer to the applicable electrical requirements.

•Make sure that the electrical data on the rating plate agrees with the pow- er supply.

•Always use a correctly installed shockproof socket.

•Do not use multiple plugs and exten- sion cables. There is a risk of fire.

•All replacements of power supply ca- ble must be carried out by our Serv- ice.

•Make sure not to squash or cause damage to the mains plug and cable behind the appliance.

•Do not pull the mains cable to dis- connect the appliance. Always pull the mains plug.

•The plug must be dry.

The data about mains voltage, type of current and the necessary fuse are on the rating plate and in the “TECHNI- CAL INFORMATION” chapter. The rat- ing plate is behind the load door (see the “PRODUCT DESCRIPTION” chap- ter).

The appliance has a power supply ca- ble with plug fitted with 13 A fuse. If necessary, replace the fuse in the plug by 13 A ASTA BS 1363/A approved fuse.

The wires in the power supply cable are coloured as follow: