American Dryer Corp M31 Lower Front Panel Removal, Upper Front Panel Removal, TOP Cover Removal

For Models M31,M50,M75

Part Locations and Removal

LOWER FRONT PANEL REMOVAL:

Remove the lint drawer. Remove the four screws located just below the loading door. Tilt the top of the panel out and lift the panel up and away from the dryer.

UPPER FRONT PANEL REMOVAL:

Remove the four screws located just above the top loading door. Tilt the bottom of the panel out and lift the panel up and away from the dryer.

For Models M31,M50,M75

Tilt the bottom of the panel out and lift the panel up. Align support rod into hole to support control panel. Disconnect the electrical connections. Remove screw from hinge to remove the control panel.

DOOR

SWITCH

SUPPORT

ROD

TOP COVER REMOVAL:

First remove the back guard, the four screws holding top cover. Next pull top cover toward the rear of the dryer and lift up.

For Models M31,M50,M75

LINT BOX/BLOWER ASSEMBLY REMOVAL:

Unplug the motor harness.

For M31, remove two screws above the lint drawer. For M50, M75, also remove two screws beneath the gasket on the left and right side of the lint drawer. Also, unplug the exhaust temperature probe.

Unplug two connections on the exhaust hi-limit at the left of the lint box. Also disconnect the two connections for the lint drawer switch, located at the back of the lint box. The lint box may now be pulled out through the front of the dryer.

For Models M31,M50,M75

LINT DRAWER

SWITCH

EXHAUST

HI-LIMIT

4 American Dryer Corporation 450280-1