Amana W10216186A manual Complete Installation, Reverse the door handle, Reinstalling the door

4.Move hinge to the other side and reattach with the 4 screws removed in Step 2. Make sure locator pins line up in holes and drive the top 2 screws in place first to help drive locator pins into proper location.

5.Set the inner door assembly aside.

Reverse the door handle

1.Place the outer door assembly face down on work space.

2.Remove the 6 screws that hold the intermediate door to the outer door assembly. Remove the intermediate door, and set hinge shield aside. Remove the hinge hole cover.

B C

A

A. Intermediate door

B. Hinge shield

C. Hinge hole cover

3.Rotate the window assembly 180º and reattach the intermediate door, hinge shield, and hinge hole cover with the 6 screws removed in Step 2.

Reinstalling the door

1.Place the inner door assembly into the outer door assembly. To fit correctly, the inside door assembly edge is completely inside the outside door assembly edge.

2.Reassemble the inner and outer door assemblies with the 5 screws.

3.Remove existing label from the opposite side of the door and discard. Find label provided with the Use and Care Guide and apply over original hinge holes.

4.Align the door by placing the locating tabs on the hinge with the locating holes on the dryer front panel. Insert and tighten the center hinge screw. The door will hang in place while you insert and tighten the remaining 4 screws.

NOTE: Two or more people may be needed to reattach the dryer door.

A

B

C

A. Dryer door

B. Dryer front panel

C. Insert this hinge screw first.

5.Close the door and check that it latches securely.

6.Check for fingerprints on the glass. Clean the glass if necessary.

Complete Installation

1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check that you have all of your tools.

3.Dispose of/recycle all packaging materials.

4.Check the dryer’s final location. Be sure the vent is not crushed or kinked.

5.Check that the dryer is level. See “Level Dryer.”

6.For power supply cord installation, plug into an outlet. For direct wire installation, reconnect power.

7.Remove the blue protective film on the console and any tape remaining on the dryer.

8.Read “Dryer Use.”

9.Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.

10.Select a Timed Dry heated cycle, and start the dryer. Do not select the Air Dry Temperature setting.

If the dryer will not start, check the following:

■Controls are set in a running or “On” position.

■The Start button has been pushed firmly.

■Dryer is plugged into an outlet and/or electrical supply is connected.

■Household fuse is intact and tight, or circuit breaker has not tripped.

■Dryer door is closed.

This dryer automatically runs an installation diagnostic routine at the start of its first cycle.

If you receive an L2 code, there may be a problem with your home power supply keeping the dryer’s heater from turning on. See “Troubleshooting.”

If you receive an AF code, your dryer vent may be crushed or blocked. See “Troubleshooting.”

NOTE: You may notice an odor when the dryer is first heated. This odor is common when the heating element is first used. The odor will go away.

17