Amana W10216186A manual Installation clearances, Dryer Dimensions, Closet installation Dryer only

Page 5

A level floor with a maximum slope of 1" (25 mm) under entire dryer. (If slope is greater than 1" [25 mm], install Extended Dryer Feet Kit, Part Number 279810.) Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.

For a garage installation, you will need to place the dryer at least 18" (460 mm) above the floor. If you are using a pedestal, you will need 18" (460 mm) to the bottom of the dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Custom undercounter installation - Dryer only

0"

(0 mm)

38" min.

(965.2 mm)

1"*

 

 

 

 

 

27"

 

 

 

1"*

(25 mm)

 

 

(686 mm)

 

 

 

(25 mm)

 

 

 

 

*Required spacing

Closet installation - Dryer only

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.

Installation clearances

The location must be large enough to allow the dryer door to open fully.

Dryer Dimensions

50½"

(1282.7 mm)

 

14" max.*

 

 

(356 mm)

48 in.2*

 

 

 

(3100 mm2)

 

18" min.*

 

 

(457.2 mm)

 

 

 

 

24 in.2*

 

 

 

(1550 mm2)

1"*

31½"

5"**

 

(25 mm)

(800 mm)

(127 mm)

 

 

A

 

 

3"*

(76 mm)

3"*

(76 mm)

B

38"

(965.2 mm)

*31½" (800.1 mm)

A. Side view - closet or confined area

B. Closet door with vents

*Required spacing

**For side or bottom venting, 0" (0 mm) spacing is allowed.

Recessed or closet installation - Dryer on pedestal

27"

(686 mm)

*Most installations require a minimum 5" (127 mm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”

Installation spacing for recessed area or closet installation

The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of 0" (0 mm) clearance on the sides and rear. Recommended spacing should be considered for the following reasons:

Additional spacing should be considered for ease of

installation and servicing.

1"

 

 

 

 

 

27"

 

 

(25 mm)

 

 

(686 mm)

14" max.*

(356 mm)

18" min.*

(457.2 mm)

 

1"

 

1"*

 

 

31½"

 

 

5"**

 

 

 

 

 

 

 

(25 mm)

(25 mm)

(800 mm)

(127 mm)

Additional clearances might be required for wall, door, and

floor moldings.

Additional spacing should be considered on all sides of the

dryer to reduce noise transfer.

For closet installation, with a door, minimum ventilation

openings in the top and bottom of the door are required.

Louvered doors with equivalent ventilation openings are

acceptable.

Companion appliance spacing should also be considered.

AB

A. Recessed area

B. Side view - closet or confined area

*Required spacing

**For side or bottom venting, 0" (0 mm) spacing is allowed.

5

Image 5
Contents W10216186A Electronic Electric DryersDryer Safety Table of ContentsImportant Safety Instructions Tools and Parts Installation InstructionsOptional Pedestal Location RequirementsDryer Dimensions Installation clearancesCustom undercounter installation Dryer only Closet installation Dryer onlyMobile home additional installation requirements Installation spacing for cabinet installationElectrical Requirements It is your responsibilityIf your outlet looks like this If connecting by direct wireElectrical Connection Power Supply Cord Direct WireStyle 1 Power supply cord strain relief Style 2 Direct wire strain relief Wire connection Power supply cordScrew Wire connection Direct wireBDE CG F Optional 3-wire connection If this is a new vent system Vent material If using an existing vent systemVenting Requirements Plan Vent System Optional exhaust installationsAlternate installations for close clearances Install Leveling Legs Install Vent SystemSpecial provisions for mobile home installations Vent system chartLevel Dryer Connect VentReverse Door Swing Remove the doorReinstalling the door Complete InstallationReverse the door handle If the dryer will not start, check the followingStarting Your Dryer Dryer USETo use an Automatic Cycle To make changes during an Automatic CycleStopping Your Dryer Pausing or RestartingControl Locked Drying and Cycle TipsCycles Status LightsOptions Modifiers End of Cycle SignalChanging Cycles, Options, and Modifiers Drying Rack OptionsCleaning the Lint Screen Cleaning the Dryer LocationEvery load cleaning Dryer CareRemoving Accumulated Lint Cleaning the Dryer InteriorVacation and Moving Care Changing the Drum LightDryer Results TroubleshootingDryer Operation Lint on load Cycle time too shortStains on load or drum Loads are wrinkledFor Assistance and Service Assistance or ServiceIf you need replacement parts W10216186A Amana Laundry WarrantyThis limited warranty does not cover

W10216186A specifications

The Amana W10216186A is a top-tier refrigerator that stands out due to its combination of modern technology, impressive features, and thoughtful design. Built with the user in mind, this model represents a commitment to optimal food storage and energy efficiency.

One of the main features of the Amana W10216186A is its spacious interior. With generous storage capacity, the refrigerator accommodates all your groceries with ease. The adjustable shelves offer flexibility, allowing users to customize the layout to fit taller items or organize produce efficiently. Additionally, the crisper drawers are designed to keep fruits and vegetables fresh for longer, sealing in moisture while providing optimal airflow.

The refrigerator employs innovative cooling technologies that help maintain a consistent temperature throughout the unit. This is crucial for preserving the quality and freshness of food. With a temperature control system that is precise and easy to adjust, users can ensure their food is kept at the ideal temperature.

Energy efficiency is another significant characteristic of the Amana W10216186A. It operates on a low energy consumption rating, making it an environmentally friendly choice without sacrificing performance. This not only saves users money on their electricity bills but also contributes to a more sustainable lifestyle.

The exterior of the Amana W10216186A features a sleek, stainless-steel finish that not only looks modern but is also resistant to fingerprints, making maintenance a breeze. The appliances also come equipped with a user-friendly control panel, providing easy access to temperature settings and other features.

In terms of technological advancements, this model includes features like an advanced cooling system and a sound-dampening technology that minimizes operational noise. These enhancements ensure that the refrigerator runs quietly, making it an ideal addition to any kitchen.

Overall, the Amana W10216186A is a highly regarded refrigerator that brings together style, functionality, and efficiency. Its combination of user-friendly features, innovative technologies, and ample space makes it an excellent choice for those looking to upgrade their kitchen appliances. Whether you are storing daily groceries or meal prepping for the week, this refrigerator is designed to meet a variety of needs while ensuring optimal food preservation.