Amana W10216186A manual Venting Requirements, If using an existing vent system

Page 13

Venting Requirements

WARNING

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death or fire.

WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS.

IMPORTANT: Observe all governing codes and ordinances.

The dryer exhaust must not be connected into any gas vent, chimney, wall, ceiling, attic, crawlspace, or a concealed space of a building.

If using an existing vent system

Clean lint from the entire length of the system and make sure exhaust hood is not plugged with lint.

Replace any plastic or metal foil vent with rigid or flexible heavy metal vent.

Review Vent system chart. Modify existing vent system if necessary to achieve the best drying performance.

If this is a new vent system

Vent material

Use a heavy metal vent. Do not use plastic or metal foil vent.

4" (102 mm) heavy metal exhaust vent and clamps must be used. DURASAFE™ venting products are recommended.

4"

102 mm

4" (102 mm) heavy metal exhaust vent

DURASAFE™ vent products can be purchased from your dealer or by calling Whirlpool Parts and Accessories. For more information, see the “Assistance or Service” section.

Rigid metal vent

For best drying performance, rigid metal vents are recommended.

Rigid metal vent is recommended to avoid crushing and kinking.

Flexible metal vent

Flexible metal vents are acceptable only if accessible for cleaning.

Flexible metal vent must be fully extended and supported when the dryer is in its final location.

Remove excess flexible metal vent to avoid sagging and kinking that may result in reduced airflow and poor performance.

Do not install flexible metal vent in enclosed walls, ceilings, or floors.

The total length of flexible metal vent should not exceed 7¾ ft (2.4 m).

Elbows

45° elbows provide better airflow than 90° elbows.

GoodBetter

Clamps

Use clamps to seal all joints.

Exhaust vent must not be connected or secured with screws or other fastening devices that extend into the interior of the duct and catch lint. Do not use duct tape.

Clamp

Exhaust

Recommended hood styles are shown here.

B

A

4"

(102 mm)

4" (102 mm)

A. Louvered hood style

B. Box hood style

The angled hood style (shown here) is acceptable.

4"

(102 mm)

2½" (63.5 mm)

An exhaust hood should cap the vent to keep rodents and insects from entering the home.

Exhaust hood must be at least 12" (305 mm) from the ground or any object that may be in the path of the exhaust (such as flowers, rocks or bushes, snow line, etc.).

13

Image 13
Contents W10216186A Electronic Electric DryersDryer Safety Table of ContentsImportant Safety Instructions Tools and Parts Installation InstructionsOptional Pedestal Location RequirementsDryer Dimensions Installation clearancesCustom undercounter installation Dryer only Closet installation Dryer onlyMobile home additional installation requirements Installation spacing for cabinet installationElectrical Requirements It is your responsibilityIf your outlet looks like this If connecting by direct wireStyle 1 Power supply cord strain relief Power Supply Cord Direct WireElectrical Connection Style 2 Direct wire strain relief Wire connection Power supply cordScrew Wire connection Direct wireBDE CG F Optional 3-wire connection Venting Requirements If using an existing vent systemIf this is a new vent system Vent material Alternate installations for close clearances Optional exhaust installationsPlan Vent System Install Leveling Legs Install Vent SystemSpecial provisions for mobile home installations Vent system chartLevel Dryer Connect VentReverse Door Swing Remove the doorReinstalling the door Complete InstallationReverse the door handle If the dryer will not start, check the followingStarting Your Dryer Dryer USETo use an Automatic Cycle To make changes during an Automatic CycleStopping Your Dryer Pausing or RestartingControl Locked Drying and Cycle TipsCycles Status LightsOptions Modifiers End of Cycle SignalChanging Cycles, Options, and Modifiers Drying Rack OptionsCleaning the Lint Screen Cleaning the Dryer LocationEvery load cleaning Dryer CareRemoving Accumulated Lint Cleaning the Dryer InteriorVacation and Moving Care Changing the Drum LightDryer Operation TroubleshootingDryer Results Lint on load Cycle time too shortStains on load or drum Loads are wrinkledIf you need replacement parts Assistance or ServiceFor Assistance and Service This limited warranty does not cover Amana Laundry WarrantyW10216186A

W10216186A specifications

The Amana W10216186A is a top-tier refrigerator that stands out due to its combination of modern technology, impressive features, and thoughtful design. Built with the user in mind, this model represents a commitment to optimal food storage and energy efficiency.

One of the main features of the Amana W10216186A is its spacious interior. With generous storage capacity, the refrigerator accommodates all your groceries with ease. The adjustable shelves offer flexibility, allowing users to customize the layout to fit taller items or organize produce efficiently. Additionally, the crisper drawers are designed to keep fruits and vegetables fresh for longer, sealing in moisture while providing optimal airflow.

The refrigerator employs innovative cooling technologies that help maintain a consistent temperature throughout the unit. This is crucial for preserving the quality and freshness of food. With a temperature control system that is precise and easy to adjust, users can ensure their food is kept at the ideal temperature.

Energy efficiency is another significant characteristic of the Amana W10216186A. It operates on a low energy consumption rating, making it an environmentally friendly choice without sacrificing performance. This not only saves users money on their electricity bills but also contributes to a more sustainable lifestyle.

The exterior of the Amana W10216186A features a sleek, stainless-steel finish that not only looks modern but is also resistant to fingerprints, making maintenance a breeze. The appliances also come equipped with a user-friendly control panel, providing easy access to temperature settings and other features.

In terms of technological advancements, this model includes features like an advanced cooling system and a sound-dampening technology that minimizes operational noise. These enhancements ensure that the refrigerator runs quietly, making it an ideal addition to any kitchen.

Overall, the Amana W10216186A is a highly regarded refrigerator that brings together style, functionality, and efficiency. Its combination of user-friendly features, innovative technologies, and ample space makes it an excellent choice for those looking to upgrade their kitchen appliances. Whether you are storing daily groceries or meal prepping for the week, this refrigerator is designed to meet a variety of needs while ensuring optimal food preservation.