4.Electrical Connections
A wiring diagram is located inside the control box for connection data.
If local codes permit, power to the dryer can be made by the use of a flexible U.L. listed power cord/pigtail (wire size must conform to rating of dryer), or the dryer can be hard wired directly to the service breaker panel. In both cases, a strain relief must be installed where the wiring enters the dryer.
IMPORTANT: A separate protected circuit must be provided to each dryer.
The electrical input connections on ALL
A ground lug is provided in the rear electrical box to connect your service ground.
Single-Phase Electrical Lead Connections
Black
+
Positive
White or Red
+
Neutral or L2
Green
+
Ground
FOR 110V APPLICATIONS
18