Installation Instructions
2 PREPARE THE PEDESTAL
APull the drawer out
as far as it will go.
BRemove
screws from drawer slides. Slide drawer out of the base and set aside.
FOR DRYERS ONLY:
CLocate the 4 support pads from the parts package. Each pad has 2 protrusions that fit into the holes on top of the pedestal.
Press the rubber pads into each set of corner holes on the top of the pedestal as shown.
NOTE: The support pads should be installed on the dryer only. DO NOT INSTALL THESE PADS ON THE WASHER PEDESTAL.
3INSTALL THE PEDESTAL
TO THE WASHER OR DRYER
APlace the pedestal against the bottom of the unit. Check to be sure the drawer front is at the front of the unit.
BAlign the holes in the pedestal with the holes in the bottom of the unit. Use a Phillips screwdriver to install the 4 screws through the pedestal and into the
CSlide the pedestal toward the unit, until it is aligned front to back. Use an
8 mm socket wrench to securely tighten the screws.
2