Attach pedestal to appliance

1.Turn pedestal on its side to match orientation to appliance.

2.Slide pedestal up to appliance and line up holes in mounting brackets with holes in appliance base.

3.Attach rear and front brackets to appliance base with supplied screws into aligning holes - one in each front bracket and two in each rear bracket.

4.Using more than one person, carefully return appliance and ped- estal to upright position.

CAUTION

EXCESSIVE WEIGHT HAZARD

To avoid back or other injury, have more than one person move or lift the appliance.

IMPORTANT

DO NOT use open dispenser drawer of washer or dispenser cavity as hand-hold location when tipping washer upright. Serious damage could occur to your washer.

5.After retuning appliance upright, loosen each mounting screw going into appliance base. Allow the appliance to settle in the brackets and retighten each mounting screw.

WASHER:

DRYER:

Installing or re-installing appliance

Washer on pedestal:

1.Slide washer/pedestal into place.

2.Check for levelness and rock all four (4) legs again. Repeat until level and solid.

3.Refer to Washer Installation Instructions for complete details on installing water, drain, or electrical.

Dryer on pedestal:

1.Slide dryer/pedestal into place.

2.Check for levelness and rock all four (4) legs again. Repeat until level and solid.

3.Refer to Dryer Installation Instructions for complete details on installing electrical, gas, or exhaust venting.