PROBLEM
Washer fills and drains without running
Washer drains during wash and rinse cycles, or water siphons out
POSSIBLE CAUSE
Cycle control knob is not pointing to a number in the cycle.
Drain hose is lower than the water level in the washer.
SOLUTION
Set cycle control knob on correct number in the cycle.
Adjust drain hose so that it is higher than the water level in the washer.
2.If your problem is not due
to one of the items listed in Step 1 . . .
Contact the dealer from whom you purchased the unit or an authorized Whirlpool service company.
3.If you need FSP* replace- ment parts . . .
FSP is a protected trademark of Whirlpool Corporation for quality parts. Look for this symbol of quality whenever you need a replacement
assembly covered
23