E
Leveling
washer
Stack two corner posts (A) on top of each other. Tilt washer backwards and slide corner posts under washer 7.6 cm (3 inches) from each side of washer as shown.
(A) 
7.6 
1.3 cm
(1/2")
C
E
A
B
Screw nut (B) down on legs to within 1.3 cm (1/2 inch) of base (C).
D
Insert legs into correct holes at each front corner of washer until nuts touch washer (D). DO NOT tighten nuts until washer is level.
Tilt washer backward and remove corner posts. Gently lower washer to floor.
Move washer to its final location. Remove cardboard or hardboard from under washer.
Tilt washer forward, raising back legs 2.5 cm (1 inch) off of floor to adjust rear
If washer is not level, adjust the front legs (E) up or down. Repeat above step.
When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate.
(B) 
(C) 1.3 
(D) 
2.5 
(E) 
F
Securing
drain hose
approx. 41 cm
(16")
41 
NOTE: Use shipping strap to secure drain hose. Water pressure could cause drain hose to come out of standpipe or laundry tub if drain hose is not secured.
A
After shipping strap has been removed from washer, look for the |
|
| |
words “cut here” marked on the shipping strap, about 41 cm | cut here | 41 | |
(16 inches) from the plug end. Cut the shipping strap at this mark | |||
|
|
(A). | (A) |
|
Continued on page 8. | 8 |
7