Whirlpool 3397512 installation instructions Inlet valves are, Paneld

Use new hoses and washers that came with your Whirlpool washer/dryer.

13. coupling washer

Insert a flat washer into each end of the inlet hoses. Check that washers are firmly seated in couplings.

Inlet valves are

14.

Attach hose to bottom inlet valve opening first, Then second hose to top inlet valve. Tighten couplings by hand, then use pliers to make an additional two-thirds turn.

Numbers correspond to steps.

IMPORTANT: THIS PROCEDURE MUST BE FOLLOWED TO ASSURE PROPER INSTALLATION.

Drain	, Clamp
Hose

To prevent the drain hose from coming off or leaking, it

must be installed per the following instructions:

1, Wet the inside end of the drain hose with tap water. DO NOT USEANY OTHERLUBRICANT.

2.Squeeze ears of clamp with pliers to open and place clamp over the end of the drain hose.

3.While holding clamp open, work end of drain hose onto drain connector until drain hose is within l/4 inch of ribbed stop.

4.When the end of the drain hose is within l/4 inch of ribbed stop, position clamp on drain hose so that the bottom of the clamp is l/4 inch from the end of the hose. Release pliers.

16 Open clamp n and slide over

“hook” end of drain hose to secure the rigid and corrugated sections together.

17, Move washer/dryer

close to final position. Put “hook“end of drain hose

into laundry tub or standpipe.

Check for proper length of drain hose.

DO NOT FORCE EXCESSLENGTHOF DRAIN HOSE DOWN THESTANDPIPE.THIS COULD CAUSE SIPHONING.

Before attaching water inlet hoses, run water through both faucets into a bucket. This will get rid of particles in water lines that might clog hoses. Mark which is the hot water faucet,

19.

Attach bottom hose (inlet marked “H”) to hot water faucet. Attach top hose (inlet marked “C”)to cold water faucet. Tighten the coupling to the faucet by hand, then use pliers to make final two-thirds turn.

PANELD