Haier HWM78-0528T user manual Reserve,Process,remain time digitron, Power button

Reserve,Process,remain time digitron "Power" button

It displays "--" during detecting.

It displays remained reserve time (hour).

It displays total remained time (min). If the total time exceeds 99 minutes, it uses "A" on tens digit to represent100 minutes, and uses "b" to represent 110 minutes.E.g. "A3" represents 103 minutes.

It displays abnormal symbol in abnormal situation. (See to Page15)

Push the "power" button to switch on the power.

Under power-on mode, push it to switch off the power. Push the "power" button to switch on the power. If the "start/pause" button is not pushed, the machine will switch off the power automatically after 5 minutes.

	HT
INUTES)	LIG
	H
	AS
	FL
LATER)
	PROGRAM/RESERVE

POWER

ON/OFF

WATER

LEVEL Digital display

Fuzzy logic control

10 water level selection

PROGRAM/RESERVE button

Push down the "program/ reserve" button. You can select one program of ten which is standard,soak heavy, gentle,save,cotton, single wash,rinse spin,single spin,tub clean, air dry;

Push the"program/ reserve" button to set the reserve wash program morethan two seconds continuously;

When the "reserve" function is activated, the indicator light of the program you have set will be off. The "reserve (hour)" and "time remain" indicator lights will be on;

During reserve procedure, push the "reserve" button to display the reserve mode.To change the running program or cancel the reserve setting, you need to switch off the power and make new selection;

WATER LEVEL button

The washing machine can detect the laundries automatically. After detection,it will set the water level to suitable value among 4, 6, 8,and 10 automatically.

You can also set water level by yourself. After the machine is started, it will not set water level automatically. You shall push the "start/pause" button to make new setting.

If there's water inside the tub, the machine cannot detect the laundries and will display water level 6 .

If save program is selected, it will display water level 2 . When water level 2 is reached in water filling, it will perform washing while filling water.When water level 3 is reached, it will change to normal washing.

During operation of wash and rinse program, you can push down the "water level" button to add water. When you release the button, or it reaches the overflow water level, the machine will stop adding water.

The water level decided may be different from actual value because of the different moisture level of the laundries.

Attention As	selecting the water level 1,3,5,7,9;the light
is	Flashing;
As	selecting the water level 2,4,6,8,10;the light
is	lighting;