Steps for Installation
Select a away suitable location for the washer on a hard even surface from direct sunlight or heat source e.g. radiators, base board heaters, cooking appliances etc.Any floor unevenness should be corrected with the leveling legs located on the bottom corners of the washer.The washer must be placed at room temperature.You must not place washer where the temperature is at below freezing.
Installing Your Washer:
Read through these instructions carefully before installation.
1.Connect the hot and cold water inlet hoses to the hot and cold water faucet.
2.Connect the other end to the corresponding washer inlet located at the back of machine.
Cold water inlet hose
Hot water inlet hose
Note: You may have to use pliers to tighten the coupling. Do not over tighten because you may cause damage to the valve.
You should use the new
16