RJP-110F Remote Jack Pack Desk Top Hole Drilling / Mounting
Hole Drilling Tools Required
- Drill Bit 1/4”
- Drill
-
- Center Punch | 3/8" Max. Thread Depth |
-Masking Tape
-Lightweight Hammer
Parts List
•Drilling Template
•
(4-Required)
Determine
Thickness of
Desk Top
Desk Top
Caution: Screw Length
Note: Length of the screws provided (M4 x 30mm) is limited to usage for a desk top thickness of 3/4 inches. For other desk top thicknesses, determine screw length allowing for the 3/8” maximum thread depth of the RJP screw holes.
Select Screw Length Based on Limitations of Desk Top Thickness and RJP Thread Depth
M4 Threaded Screw
Drilling Setup and Procedure
1.Position hole drilling template on cabinet surface or desk top.
2.Tape the template into position using the masking tape.
3.Using the
Note: Be sure the hole drilling indents are suffi- ciently deep enough to center and guide the drill bit. Or, use a smaller size drill bit just to start the hole recess.
4.Drill the four holes using the 1/4” drill bit.
5.Clean up and remove any residue from drilling the holes.
6.Install the RJP on the desk top using the thread- ed screws and lock washers provided*.
7.Tighten all screws securely.
8.Make all connections from the RJP, to the TV dis- play panel and any other
9.Test RJP operation.
*The maximum depth the M4 screws can be thread- ed into the RJP bosses is 3/8”. Use spacers if nec- essary to compensate for excessive screw length.
Maximum screw length is 3/8” plus depth of cabi- net or desk top.
DDrill Hole Template