Humminbird ProAngler manual Step Three Permanently Mount the Transducer

Page 14

INSTALLATION

INSIDE THE HULL INSTALLATION

3.Power up the Control Head.

4.Run the boat at various speeds and water depths while observing the screen on the Control Head. If the unit functions well at low speeds but begins to skip or miss the bottom at higher speeds, the transducer needs to be moved. If depth performance is required, test the fishfinder in water at the desired depth. Test different locations in the hull until the optimum performance is achieved.

Step Three - Permanently Mount the Transducer

1.Once the mounting location is determined, mark the position of the transducer.

2.Remove the water from inside the hull and thoroughly dry the mounting surface. If the surface is excessively rough, it may be necessary to sand the area to provide a smooth mounting surface.

Ensure the mounting area is clear and dry.

3.Mix an ample quantity of two-part slow-cure epoxy slowly and thoroughly. Avoid trapping air bubbles.

4.Coat the face of the transducer and the inside of the hull (Figure 16).

5.Press the transducer into place with a slight twisting motion to purge any trapped air from underneath, keeping the pointed end of the transducer body pointed forward (Figure 17).

Note: Proper operation requires the pointed end of the transducer body to face towards the bow.

6. Weight the transducer so it does not move while the epoxy is curing.

When the epoxy cures, no water is necessary inside the hull. Neither water, spilled gasoline, or oil will affect the performance of the transducer.

Image 14
Contents Page Parts Supplied AccessoriesInstallation Overview Determining How to Mount the Transducer Trolling Motor Mounting Alternate Transducers and Mounting MethodsPortable Mounting Thru-Hull MountingBeginning Installation Transducer ExchangeTransom Installation Step One Determine Where to Mount the TransducerStep Two Drill the Mounting Holes Step Three Assemble the TransducerPage Confirm the pivot angle has not changed Step Five Adjust the Running Position of the TransducerStep Four Mount the Transducer to the Transom Page Step Six Route the Cable Step Two Test the Mounting Location Inside the Hull InstallationStep One Determine the Mounting Location Page Step Three Permanently Mount the Transducer Step Two Connect the Power Cable to the Boat Control Head InstallationStep One Determine Where to Mount Page Step Three Drill the Mounting Holes Step Four Run the CablesPage Step Five Assembling the Connector Holder Your Humminbird is now ready for operationTest the Installation Available Accessories Interpreting the ON-SCREEN Information Page Control Functions Page Page Page Page Page Page Page Using Diagnostic