Humminbird Wide View manual

Page 34

ID

ID is the automatic identification of target returns based on the strength of the returned signal and other factors. Three options are available: ID "On" displays targets as one of three different size fish symbols.

Assuming the dual beam transducer is selected, these fish symbols can be either hollow, indicating that the target is detected in the wide beam only, or solid, indicating that the target is detected in the narrow beam, and is located directly under the boat.

"ID+", the default setting, provides more information about the location of the target by attaching depth "strings" showing the digital depth of the target. When there are numerous targets on-screen, not every target depth is shown, to avoid excessive clutter on-screen.

Image 34
Contents Page Installation Overview AccessoriesParts Supplied Determining How to Mount the Transducer Trolling Motor Mounting Alternate Transducers and Mounting MethodsPortable Mounting Thru-Hull MountingBeginning Installation Transducer ExchangeTransom Installation Step One Determine Where to Mount the TransducerStep Two Drill the Mounting Holes Step Three Assemble the TransducerPage Step Four Mount the Transducer to the Transom Step Five Adjust the Running Position of the TransducerConfirm the pivot angle has not changed Page Step Six Route the Cable Step One Determine the Mounting Location Inside the Hull InstallationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Step One Determine Where to Mount Control Head InstallationStep Two Connect the Power Cable to the Boat Page Step Three Drill the Mounting Holes Step Four Run the CablesPage Step Five Assembling the Connector Holder Your Humminbird is now ready for operationTest the Installation Testing the Installation Using the Wide View Page Page Page Control Functions Transducer Page Sensitivity Page Range ZoomPage Bottom Alarm Fish AlarmPage TripLog System Options Page Advanced Features Wide Side OperationPage