Humminbird LCR 40.ID manual Troubleshooting, Nothing happens when I turn the unit on

Page 34

www..reelschel matic..com

MAINTENANCE AND WARRANTY

TROUBLESHOOTING

TROUBLESHOOTING

Do not attempt to repair the fishfinder yourself. There are no user serviceable parts inside, and special tools and techniques are required for reassembly to ensure the waterproof integrity of the housing. Repairs should be performed only by authorized Humminbird technicians.

Many requests for repair received by Humminbird involve units that do not actually reed repair. These units are returned “no problem found.” If you have a problem with your Humminbird, use the following troubleshooting guide before calling Customer Support or sending your unit in for repair. Your Humminbird fishfinder contains several tools that can aid in determining if there is a problem and how to isolate and repair the problem in many cases.

1. Nothing happens when I turn the unit on.

Check the power cable connection at both ends. Be sure the cable is connected correctly to a reliable power source - red lead to positive, black lead to negative or ground. Ensure the power available at the mount is between 10 and 20 VDC. If the unit is wired through a fuse panel, ensure the panel is powered. Often accessory fuse panels are controlled by a separate switch or the ignition switch. Also, often a fuse can appear to be good when in fact it is not. Check the fuse with a tester or replace it with a fuse known to be good.

Check the power connection to the unit. It is possible to force the power cable connector into the cable holder incorrectly. If the connector is reversed, the unit will not work. Examine the contacts on the back of the unit to ensure there is no corrosion. Finally, ensure the unit is firmly seated on the mount. The electrical contacts are not made until the unit is fully seated.

Ensure the metal cable retainer is properly installed in the mount. If not, the power connected may push out when the unit is put on the mount.

2. There is no transducer detected.

Most Humminbird fishfinders have the ability to detect and identify that a transducer is connected. If at power up, a message indicates "transducer not connected,” only simulator operation is possible. First, ensure that an appropriate transducer connector is positioned correctly in the connector holder, and that the unit is fully seated on the mount. Your Humminbird fishfinder will work only with an appropriate transducer; check the accessory guide for compatibility.

Image 34
Contents Page Table of Contents Transducer Mounting Procedure Transducer Mounting OptionsTransom Mounting Procedure Page Page Page Inside Hull Mounting Procedure Page Installing the LCR Installing the Cables Other Mounting OptionsPage Installation Test the InstallationIntroduction Theory of OperationUsing the LCR Using the LCR How Does Total Screen Update Work? Total Screen UpdateWhat is Total Screen Update? How To Use Total Screen UpdateOperational Instructions LCRUsing the LCR Automatic or Manual Mode How To Use Zoom What Zoom DoesSome Additional Things You Should Know About Zoom Bottom LockFish Alarm Bottom AlarmUsing the LCR Reading will not be seen while in the manual mode Additional Information Some additional things you should know about the LCRCaring for Your LCR Learning to USE Your LCR StepUsing the LCR Using the LCR Learning to Read the Display Using the LCR Maintenance and Warranty MaintenanceTroubleshooting Nothing happens when I turn the unit onThere is no bottom reading visible on the display Unit comes on before I press POWER, and wont turn off Humminbird ONE Year Full Warranty Service Policy Customer Support