Humminbird LCR 40.ID manual Fish Alarm, Bottom Alarm

Page 23

www..reelschel matic..com

USING THE LCR

OPERATIONAL INSTRUCTIONS

In bottom lock the expanded information always comes onto the screen at the same location. However, as the information moves across the screen and as the bottom contour moves up or down, the displayed information will also move so that you can see the actual bottom contour. Remember, in bottom lock, you will be seeing up from the bottom and this expanded area will move up or down as the bottom contour changes.

When the bottom lock is activated, the LCR will change to the lowest depth range, so that the bottom can be tracked to the maximum depth.

6.Audible Alarms: The LCR is equipped with two audible alarms, a Fish Alarm and a Bottom Alarm.

Fish Alarm:

The LCR Fish Alarm will give a short alarm sound anytime a return is detected between the boat and the bottom. It will not alarm on the bottom, but only on objects off the bottom.

To activate the Fish Alarm press the Fish Alarm “On/Off” button. The indicator in the lower part of the screen will indicate that the Fish Alarm is on. The Fish Alarm is operational only while the LCR is in the automatic mode. See “Manual Mode” in this section for use of the alarm in the manual mode.

The Fish Alarm may occasionally sound when no target is displayed. This can happen when the display sweep speed is slow such that the target was detected but gone by the time the display is updated.

To turn the Fish Alarm off, simply press the Fish Alarm “On/Off” button again.

Bottom Alarm:

The Bottom Alarm is activated by pushing the alarm “On/Off” button. When first activated the alarm is set at five feet. The desired alarm depth can he adjusted up or down by pressing the depth set button and the increase or decrease button. When the increase or decrease button is pressed once the alarm setting will change one division. If the button is held down the setting will move as tong as the button is held down. The alarm setting is indicated down the right side of the display. The Bottom Alarm may be set anywhere from 4 feet to the maximum depth. When the bottom enters the alarm range it will trigger a continuous audible signal.

The Bottom Alarm will operate both in the automatic and manual modes, however the operation is slightly different depending on what mode is on.

Image 23
Contents Page Table of Contents Transducer Mounting Options Transducer Mounting ProcedureTransom Mounting Procedure Page Page Page Inside Hull Mounting Procedure Page Installing the LCR Other Mounting Options Installing the CablesPage Test the Installation InstallationTheory of Operation IntroductionUsing the LCR Using the LCR How To Use Total Screen Update Total Screen UpdateWhat is Total Screen Update? How Does Total Screen Update Work?LCR Operational InstructionsUsing the LCR Automatic or Manual Mode What Zoom Does How To Use ZoomBottom Lock Some Additional Things You Should Know About ZoomBottom Alarm Fish AlarmUsing the LCR Reading will not be seen while in the manual mode Some additional things you should know about the LCR Additional InformationCaring for Your LCR Step Learning to USE Your LCRUsing the LCR Using the LCR Learning to Read the Display Using the LCR Maintenance Maintenance and WarrantyNothing happens when I turn the unit on TroubleshootingThere is no bottom reading visible on the display Unit comes on before I press POWER, and wont turn off Humminbird ONE Year Full Warranty Service Policy Customer Support