Humminbird Wide 3D Vista manual Using the 3D View

Page 21

A valuable accessory available for use with all Wide 3D products is Wide Side. Your unit has the capability of displaying information from a special “side-locking” transducer as shown in Figure E. See the “Advanced Feature” section for more information.

Using the View button to toggle between the three main views gives you the maximum benefit of each type of view: The 3D view gives you an excellent representation of bottom terrain and target location, The 2D view is best for determining bottom hardness and texture and locating structure or bottom detail. The combo view combines both 3D and 2D views to provide the best of both views.

USING THE 3D VIEW

At power-up, the Wide 3D Vista locates the bottom and adjusts the depth range to a setting most appropriate for that depth. The bottom will usually be displayed about 2/3 of the way down the display. Each of the six sonar beams transmits a signal at a rate of about four times per second. The returned signals from each transmit are compared and evaluated before the information is displayed, so each display update contains information gathered from several transit and receive cycles.

Image 21
Contents Page Accessories Installation OverviewParts Supplied Determining How to Mount the Transducer Portable Mounting Alternate Transducers and Mounting MethodsTrolling Motor Mounting Thru-Hull MountingTransducer Exchange Beginning InstallationStep One Determine Where to Mount the Transducer Transom InstallationStep Three Assemble the Transducer Step Two Drill the Mounting HolesStep Five Adjust the Running Position of the Transducer Step Four Mount the Transducer to the TransomConfirm the pivot angle has not changed Page Step Six Route the Cable Inside the Hull Installation Step One Determine the Mounting LocationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Control Head Installation Step One Determine Where to MountStep Two Connect the Power Cable to the Boat Page Step Four Run the Cables Step Three Drill the Mounting HolesPage Your Humminbird is now ready for operation Step Five Assembling the Connector HolderTest the Installation What YOU see on Screen Using the 3D View Page Using the 2D View Control Functions Using the Combo ViewSensitivity Menu FunctionsRange Zoom Page Bottom Alarm Page Page System Options TriplogPage Advanced Operation DiagnosticWide Side Operation Page