The diagnostic function is also very helpful during troubleshooting to determine where a problem in the system lies. A "weak" beam is usually caused by an improper sensor installation, however, if your sensor is mounted outside the hull, the problem is most likely in the sensor or the LCR 3D itself.
Operating Frequency: | 455 KHz |
Power Requirement: | 10 - 16 VDC |
Power Cable Length: | 48" |
Sensor (standard): |
|
Sensor Cone Angle: | 45 degrees |
side |
|
16degrees
Depth Ranges: | 0 to 10', 20', 40', | |
60', 80' and 99' |
| |
Zoom Ranges: 10', 20' and 40' | ||
Unit Construction: | ||
polycarbonate |
| |
housing |
|
|
Unit Dimensions: | 8 1/4" x 5 3/4" x 2" | |
Display: | ||
crystal |
|
|
Viewing Area: |
| 3 " x 4 " |
Matrix Configuration: | 128 x 128 pixels | |