Humminbird LCR 3D manual

Page 4

Once the location is determined mark and drill three 7/64” dia.. holes noted on the template. Attach the metal bracket using three #10 self threading screws supplied. Be sure to align holes in the center of the

Bracket slots. On some aluminum boats it may be necessary to use a wood back-up plate. It is important to use a silicone sealant between the screwhead and bracket in order to prevent leaking. (See Figure C)

Step 2.

BRACKET INSTALLATION (Fiberglass Boats)- If your boat has a stepped transom located below and under the main transom, the compact transducer design allows mounting in this area. This mounting location is recommended for good reading at very high speeds. (See Figure D)

To install the metal bracket on a fiberglass boat, locate the template on the transom in the same manner as for an aluminum boat. (See Figure C)

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Page Transducer Mounting Procedure Transducer Mounting OptionsTransom Mounting Procedure Page Page Page Inside Hull Mounting Procedure Installing the LCR Page Installing the Cables Other Mounting OptionsPage Before Beginning HOW the LCR 3D WorksHumminbird Advantage What YOU haveCable Connections Accessories Testing the InstallationAD-STM-7 SM-LCRPage Using the BUILT-IN Simulator What YOU see ON-SCREEN Page Page LCR 3D Button Functions Select SystemSelecting Sensitivity Setting Depth Range Factory setting Automatic Enabling Bottom Alarm Factory setting OFFEnabling Fish Alarm Factory setting OFF Using Zoom Factory Setting OFFUsing Bottom-Lock Factory setting OFF Adjusting Custom Program Factory SettingsUsing Diagnostic Factory setting OFF SHS-9
Top Page Image Contents