Humminbird TCR ID-1 manual BUILT-IN Simulator

Page 17

USING THE TCR ID-1

BUILT-IN SIMULATOR

BUILT-IN SIMULATOR

To help you learn to use your new unit, Humminbird has built a simulator into the TCR ID-1.The simulator will display a typical underwater scene, and allow you to use the controls for practice.

Activating the simulator is easy - with the unit turned off, hold down the power button for about 2 seconds, until a chirping sound begins. When you release the button, the built- in simulator will be on and ready for your practice session. Turning your unit off and back on again will disengage the simulator, for operating the TCR ID -1 in actual conditions.

NOTE: The built-in simulator will allow you to practice adjusting the sensitivity, but your adjustments will not change the readings being displayed on the screen.

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Page Table of Contents Transducer Mounting Options Transducer Mounting ProcedureTransom Mounting Procedure Page Page Page Inside Hull Mounting Procedure Page Installing the LCR Other Mounting Options Installing the CablesPage Test the Installation InstallationUsing the TCR ID-1 What is a HIGH-DEFINITION Depth SOUNDER? Why 455KHz?Compact, High-Definition Sensor BUILT-IN Simulator Fish Identification Reading the TCR ID-1 ScreenTotal Screen Update Using the TCR ID-1 Operating the TCR ID-1 Fish Alarm Bottom AlarmExample 2 Often-used function SensitivityDisplay Speed ZoomBottom-Lock Depth Range Specifications Maintenance Maintenance and WarrantyNothing happens when I turn the unit on TroubleshootingThere is no bottom reading visible on the display Unit comes on before I press POWER, and wont turn off Humminbird ONE Year Full Warranty Service Policy Customer Support
Top Page Image Contents