Humminbird TCR ID-1 manual Transom Mounting Procedure

Page 4

absorb the blow of any obstruction by rotating up out of the metal spring bracket without harming the transducer, or your boat. The transducer can be re-engaged by simply rotating the transducer down and snapping it back in place. (See Figure A)

B.Inside Hull Mount- The high speed transducer can be mounted inside the hull (without pivot assembly) using the proper two-part epoxy, such as Humminbird’s epoxy kit. Even though there is some loss of signal in shooting through the hull, your LCR will perform well with this type of installation. You cannot shoot through the hull of an aluminum boat.

C.Trolling motor Mount- This type of transducer is not supplied with your LCR. It is designed to mount on the foot of a trolling motor. You may exchange your un-used high speed transducer for a trolling motor transducer. Call the Humminbird Customer Service Department.

D.Bronz Thru-Hull Mount- This transducer is not supplied with your LCR but for an additional cost you may exchange your un-used high speed transducer for a bronz thru-hull. The bronz thru-hull transducer has a threaded stem which installs through a hole drilled in the boat hull, leaving the housing exposed under the boat. This type of installation must be used for many boats with in-board engines, because there is no suitable location on the transom away from the noise and turbulence created by the prop. A bronz thru-hull transducer should be installed by qualified personnel only.

The LCR will operate well at high speeds with a properly mounted transducer. Remember, a transducer will not work transmitting through air or through air bubbles.

1. TRANSOM MOUNTING PROCEDURE

Step 1.

MOUNTING LOCATION- It is important that the transducer be mounted on the transom where water flow is in constant contact with the transducer. You may wish to observe the rear of the boat while it is moving through the water to determine the best mounting location.

Step 2.

BRACKET INSTALLATION (Aluminum Boats)- To install the metal bracket on an

Image 4
Contents Page Table of Contents Transducer Mounting Procedure Transducer Mounting OptionsTransom Mounting Procedure Page Page Page Inside Hull Mounting Procedure Page Installing the LCR Installing the Cables Other Mounting OptionsPage Installation Test the InstallationUsing the TCR ID-1 Why 455KHz? What is a HIGH-DEFINITION Depth SOUNDER?Compact, High-Definition Sensor BUILT-IN Simulator Reading the TCR ID-1 Screen Fish IdentificationTotal Screen Update Using the TCR ID-1 Operating the TCR ID-1 Bottom Alarm Fish AlarmExample 2 Often-used function SensitivityBottom-Lock ZoomDisplay Speed Depth Range Specifications Maintenance and Warranty MaintenanceTroubleshooting Nothing happens when I turn the unit onThere is no bottom reading visible on the display Unit comes on before I press POWER, and wont turn off Humminbird ONE Year Full Warranty Service Policy Customer Support